HP StorageWorks P9000 - Disk Arrays Manual page 255

Table 63 Error codes (part code 71 10) (continued)
Part Error Error Message
Code Number
71 10 5120 The T-VOL is not selected.
71 10 5121 The data has been changed. If you select
another tab (page), the settings will be
discarded. Are you sure you want to
continue?
71 10 5122 No data has been changed.
71 10 5123 The password is invalid.
71 10 5124 You cannot select more than one
operation at a time.
71 10 5125 No target volume is selected.
71 10 6504 The number of pairs exceeds the
maximum.
71 10 7310 Unregistered error code.
71 10 731 1 The settings could not be applied.
71 10 7312 The password could not be acquired.
71 10 7313 Error details not available.
71 10 7440 An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
71 10 8001 A time-out error occurred. Please wait
for the subsystem to recover to the
normal condition, and then retry the
operation.
71 10 8534 An internal logic contradiction occurred.
71 10 8568 The Emulation Type is invalid.
71 10 8658 Some settings could not be applied
normally. Refer to the error code.
71 10 8659 There is no volume.
71 10 9002 The requested operation has completed.
71 10 9005 An error occurred. Check the error code.
71 10 9101 Do you want to cancel?
71 10 9102 Do you want to apply?
71 10 9108 The option has been changed. If you
continue processing before applying the
change, the option will be reset to the
current setting. Do you want to continue
processing?
Recommended Action
Select the T-VOL, and retry the operation.
Apply the data in the Preview list. To
stop the transaction, click [OK] and
continue the operation.
Go on to the next operation.
Check the password.
Multiple volumes cannot be processed
in the operation. Process one volume at
a time.
Select the target volume.
You cannot create a pair for the
specified S-VOL. Delete the created pair,
and retry the operation.
Please contact HP Technical Support.
Wait a while, and retry the operation.
If the same error occurs despite retrying,
please contact HP Technical Support.
Please contact HP Technical Support.
Please contact HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Retry the operation. If you get the same
message again, reboot the PC. If
necessary, please contact HP Technical
Support.
Please contact HP Technical Support.
Specify the volume of the supported
emulation type.
Check the error code in Preview list.
Check the contents, and retry.
The operation was ended normally.
Execute the next operation.
An error occurred during the indicated
operation. See the error code for each
operation in Preview list.
To cancel, click [OK].
Click [OK] to execute the operation.
To continue processing, click [OK].
Otherwise, click [Cancel].
Severity
Level
W
W
W
W
W
W
W
E
W
E
E
E
E
E
i
W
W
i
i
i
i
i
Part code 71 10 255