HP StorageWorks P9000 - Disk Arrays Manual page 137

Table 50 Error codes (part code 6005) (continued)
Part Error Error Message
Code Number
6005 8718 The specified logical path already exists.
6005 8719 Invalid RCU serial number, SSID, Link
Address or Controller ID.
6005 8720 Too many RCUs. (Four RCUs are the
maximum.)
6005 8721 Path not completely established.
6005 8722 Failure during path creation.
6005 8723 The Edit Path operation was rejected
because the specified path is the last
path of some Remote Copy pairs.
6005 8724 Specified number of paths is less than
the minimum specified on RCU Option
screen.
6005 8725 Current microcode version does not
support the specified operation.
6005 8727 The number of minimum paths exceeds
the number of normal paths.
6005 8728 The number of minimum paths exceeds
the number of normal paths.
6005 8729 An internal error occurred.
6005 8730 Invalid Logical Addresses are specified.
6005 8731 The existing logical addresses are not
equal.
6005 8732 Too many SSIDs(Only Four SSIDs are
allowed).
6005 8733 The Fibre-Remote Copy function is not
installed in the specified MCU.
Recommended Action
Check all existing logical path
addresses, and specify another link
address or port.
Check the serial number, SSID, link
address and controller ID of the RCU,
and set the correct value. Then retry the
operation. If the same error occurs,
please contact HP Technical Support.
A maximum of four RCUs are permitted,
and that many already exist.
Check the path connections between the
MCU and the RCU, then retry the
operation.
Check the path connections between the
MCU and the RCU, then retry the
operation.
Add another path, or delete all pairs on
the RCU. Then retry the operation.
The specified number of paths is less
than the minimum number of paths
specified on the RCU Option window.
The version of the microcode on the
XP512/XP48 Disk Array does not
support the specified function or
operation. Please contact HP Technical
Support.
Add the normal path(s), then set the
minimum number of paths.
Please take either of the following
actions:
Add normal paths, then delete the paths.
Decrease the number of minimum paths,
then delete the paths.
Please contact HP Technical Support.
If you are adding RCUs, specify the
same logical address.
If you are editing paths, specify the same
logical address as the existing paths.
(See the Edit Path dialog box.)
The logical addresses of all existing
paths are not the same. Delete the RCU,
then re-add it, using the same logical
address as other existing paths.
The maximum number of SSIDs (four) has
been entered. Verify that the SSIDs are
valid, delete one or more, then retry the
operation.
Install the program product key in the
MCU.
Severity
Level
W
W
W
W
W
W
W
W
W
W
E
W
W
W
W
Part code 6005 137