HP StorageWorks P9000 - Disk Arrays Manual page 246

Table 62 Error codes (part code 7105) (continued)
Part Error
Code Number
7105 8591
7105 8592
7105 8593
7105 8594
7105 8595
7105 8596
7105 8597
7105 8598
7105 8599
7105 8600
7105 8601
7105 8602
7105 8605
7105 8606
7105 8607
7105 8608
246 Message (part code group 7nnn)
Error Message
The specified pair is already set in
another group.
The command was rejected, because the
licensed capacity was exceeded.
The S-VOL is a source volume for Auto
LUN.
The S-VOL is a target volume for Auto
LUN.
The specified S-VOL does not exist.
The specified volume is a reserved
volume.
The command has been rejected,
because the number of pairs created with
the specified S-VOL has reached the
maximum.
The specified volume is not an S-VOL.
The specified volume is already an
S-VOL.
The RAID level of the specified volume
is not supported.
The specified S-VOL cannot be paired
with a backup server volume.
The command has been rejected,
because the specified S-VOL has already
been used as T-VOL of the other pair.
The Resync command was issued to a
device in the simplex status.
The operation to create L2 pair has been
rejected, because the S-VOL of L1 pair
is used as the M-VOL of Continuous
Access Synchronous Z pair.
The command has been rejected,
because the specified T-VOL is used as
M-VOL of Continuous Access
Synchronous Z pair.
The specified T-VOL is not defined.
Recommended Action
Check the contents, and retry.
Check the capacity of the installed
license key. To create more pairs,
purchase a license key for larger
capacity.
Release the Auto LUN setting.
Release the Auto LUN setting.
Refresh, then retry the operation.
Check the status of the volume.
Pairs cannot be created with the
specified S-VOL any more.
See the section "Volume pairs (S-VOLs
and T-VOLs)" in the Business Copy for
Mainframe Systems User Guide for the
composition of pairs.
Check the status of the volume.
Specify other P-VOL, and retry the
operation. Or delete the pair of the
specified volume, then retry the
operation.
Check the RAID level, and specify a
volume of the supported RAID level, then
retry the operation.
Check the contents, and retry.
The volume used as T-VOL of the other
pair cannot be used as S-VOL.
Check the pair status.
When the S-VOL of L1 pair is used as
the M-VOL of Continuous Access
Synchronous Z pair, L2 pair cannot be
created.
The requested command cannot be
executed in the current status of
Continuous Access Synchronous Z pair.
See the section "Sharing Business Copy
Z volumes" in the Business Copy for
Mainframe Systems User Guide for the
relation between the state of Continuous
Access Synchronous Z pair and the
Business Copy Z operations.
Refresh the window, and retry the
operation.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W