HP StorageWorks P9000 - Disk Arrays Manual page 214

Table 56 Error codes (part code 6610) (continued)
Part Error
Code Number
6610 55037
6610 55038
6610 55039
6610 55202
6610 55207
6610 55208
6610 55229
6610 55644
6610 56504
6610 56505
6610 56522
6610 56523
214 Message (part code group 6nnn)
Error Message
Too many mirrors in the journal.
Too many mirrors in the subsystem.
You are specifying "Mirror" for the range
and trying to manipulate the same
mirror. Select only one data volume pair
in the mirror when you specify "Mirror"
for the range.
The specified controller ID cannot be
used.
Some of the specified values are
incorrect. Two times the value of "M-JNL
Cache" plus the value of "R-JNL Cache"
must be equal to or less than 100. Or,
the value of "Threshold of start Async
JNL" must be equal to or less than the
value of "Threshold of start Sync JNL."
The specified journal number is incorrect.
Specify the correct journal number.
There are some pairs where "Mirror" is
not specified as the range in the pairs
specified to be deleted forcibly.
Specify "Mirror" as the range when you
want to delete pairs forcibly.
[Warning]
There are some pairs where "Group" is
not specified as the range in the pairs
specified to be deleted forcibly.
Other pairs in the same group may
suspend due to a failure by this
operation.
Are you sure you want to delete pairs?
There is no journal registered that has
the same CLPR number as the specified
volume.
Register a journal that has the same CLPR
number as the specified volume, then
retry the operation.
There are no secondary subsystems
available. Please register secondary
subsystems and then retry the operation.
There are no consistency groups
available. Please create unused
consistency groups and then retry the
operation.
No more mirrors can be created for the
specified volume.
Recommended Action
Check the number of mirrors in the
journal. Then delete unused mirrors, or
register them in another journal.
Check the number of mirrors in the
journal group, then delete unused
mirrors.
Check the range setting. If you specify
"Mirror," select only one data volume
pair in the mirror.
Check the specified controller ID.
The value of "Threshold of start Async
JNL" must equal or be less than the
"Threshold of start Sync JNL" value.
Specify the correct journal number.
Specify normal deletion, or specify
"Mirror" as the range.
To delete pairs, click [Yes]. Otherwise,
click [No].
Register a journal that has the same CLPR
number as the specified volume, then
retry the operation.
Register secondary storage systems, then
retry the operation.
There are no consistency groups
available. Create unused consistency
groups, then retry the operation.
Check the mirrors of the specified
volume.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W