Part Code 01 10 - HP StorageWorks P9000 - Disk Arrays Manual

Part code 01 10

Table 1 1 Error codes (part code 01 10)
Part Error
Code Number
01 10 5030
01 10 7060
01 10 7440
01 10 8100
01 10 9002
01 10 9100
01 10 9101
01 10 9102
01 10 9104
01 10 9105
01 10 9106
01 10 9107
01 10 55045
01 10 56503
01 10 56558
24 Message (part code group 0nnn)
Error Message
The displayed information has not been
changed. Try again.
An error occurred in the client logic.
An error occurred during processing. If
this problem persists, please contact HP
Technical Support.
A SIM occurred.
The requested operation is complete.
Do you want to exit?
Do you want to cancel?
Do you want to apply?
Do you want to change the mode?
The value that is under setup is not
reflected yet. Do you want to exit?
The value that is under setup is not
reflected yet. Do you want to change the
mode?
The value that is under setup is not
reflected yet. Do you want to continue
the operation?
The installation status of program
products has been changed. To update
the status immediately, click [Refresh] on
the File menu.
The unsupported JRE version is used.
Install the supported version of JRE, then
retry the operation.
Modify mode released due to inactivity.
Another user or service engineer may
have changed the configuration while
the Modify mode was released. Get
back to the Modify mode and change
the configuration again. Set the "RMI
time-out period for Modify" by using the
"Set Env." dialog box located on the
Control Panel of the Remote Web
Console to change the time-out period
for Modify mode.
Recommended Action
Specify the data to be registered in the
SVP, then retry the operation.
An error occurred in the client logic.
If this problem persists, please contact
HP Technical Support.
Retry the same operation several times.
If the same error occurs, please contact
HP Technical Support.
Click [OK].
-
To cancel, click [OK].
To execute the operation in Preview,
click [OK], if not click [Cancel].
-
To close the window, click [OK]. To not
close the window, click [Cancel].
To change the mode, click [OK]. To not
change the mode, click [Cancel].
To continue processing, click [OK]. To
stop processing, click [Cancel].
To update the status immediately, click
[Refresh].
Install the supported version of JRE.
Get back to the Modify mode and
change the configuration again.
Severity
Level
W
E
E
E
i
i
i
i
i
W
W
W
i
E
E