Part Code 5210 - HP StorageWorks P9000 - Disk Arrays Manual

Table 46 Error codes (part code 5205) (continued)
Part Error
Code Number
5205 78056
5205 78057
5205 78058

Part code 5210

Table 47 Error codes (part code 5210)
Part Error
Code Number
5210 5010
5210 9060
5210 9061
5210 9319
5210 9357
5210 59000
5210 59071
5210 65713
5210 66800
5210 66801
Error Message
The operation failed, because the current
microcode version does not support the
capacity of the specified source volume.
The operation failed, because the current
microcode version does not support the
capacity of the specified target volume.
The operation failed, because the current
microcode version does not support the
capacity of the specified reserved
volume.
Error Message
There is no monitoring data.
The plan will be deleted. Do you want
to continue?
The specified instructions will be reset.
Do you want to continue?
Do you want to cancel the migration
plan(s)?
Some errors occurred. Find on-screen
items that could not be changed.
This migration plan extends across
multiple CLPRs. Do you want to continue
this operation?
This migration plan extends across
multiple SLPRs. If you perform this
operation, the storage partition
administrator will become unable to
operate. Do you want to continue this
operation?
This migration plan is in Suspend status
because an error occurred during
migration.
This migration plan cannot be executed,
because the pool associated to the target
volume is blocked.
This migration plan cannot be executed
because the usage rate of the pool
associated to the target volume may be
100 percent or more.
Recommended Action
Check the microcode version of the
storage system.
Check the microcode version of the
storage system.
Check the microcode version of the
storage system.
Recommended Action
Change the monitor switch to ON, and
accumulate the data.
To continue processing, click [OK]. To
stop processing, click [Cancel].
To continue processing, click [OK]. To
stop processing, click [Cancel].
Click [Apply] at once.
Find error locations. If necessary, retry
the operation.
To continue processing, click [OK]. To
stop processing, click [Cancel].
To continue processing, click [OK]. To
stop processing, click [Cancel].
Check the content of the plan in the
application that specifies the migration
plan.
Restore the pool associated to the target
volume, then retry the operation.
Increase the capacity if the pool is
associated to the target volume, then
retry the operation.
Severity
Level
W
W
W
Severity
Level
i
W
i
i
i
i
i
i
W
W
Part code 5210 129