HP StorageWorks P9000 - Disk Arrays Manual page 167

Table 53 Error codes (part code 6505) (continued)
Part Error Error Message
Code Number
6505 8712 The operation was rejected due to a
'FREEZE' state.
6505 8713 The port group already exists on the
specified port.
6505 8714 An internal error occurred.
6505 8715 The number of paths is incorrect.
6505 8719 The serial number or the controller ID of
the remote subsystem is incorrect.
6505 8720 The number of registered remote
subsystems already reached the
maximum (that is, 64).
6505 8721 Path creation has not finished yet.
6505 8722 Path creation failed.
6505 8723 The Edit Path operation was rejected
because the specified path is the last
path of some Remote Copy pairs.
6505 8724 The specified number of paths is less
than the minimum number specified in
the DKC Option window.
6505 8727 The number of minimum paths exceeds
the number of normal paths.
Recommended Action
If you are performing a path operation,
retry the operation after the FREEZE
status is released.
If you are performing a pair operation,
check the DKC status, wait until the SCP
time elapses, then retry the operation.
Exchange the port type after deleting the
group setting.
Please contact HP Technical Support.
Ensure that the number of paths is
correct, then retry the operation. If the
problem persists, please contact HP
Technical Support.
Check the serial number and the
controller ID of this remote storage
system and already registered remote
storage systems, then specify the correct
values.
If the specified values are correct, check
the cable connection of the remote
storage system. If the problem persists,
please contact HP Technical Support.
Reduce the number of registered remote
storage systems, then retry the operation.
Check the path connections between the
local and the remote storage systems,
then retry the operation.
Check the path connections between the
local and the remote storage systems,
then retry the operation.
Add another path, or delete all pairs on
the remote storage system. Then retry the
operation.
Check the number of paths.
Do either of the following to recover from
the error:
If the error code is 100c, add normal
paths, then set the minimum number
of paths.
If the error code is 100d, add normal
paths, then delete paths. Alternatively,
reduce the minimum number of paths,
then delete paths.
Severity
Level
W
W
E
W
W
W
W
W
W
W
W
Part code 6505 167