HP StorageWorks P9000 - Disk Arrays Manual page 141

Table 50 Error codes (part code 6005) (continued)
Part Error Error Message
Code Number
6005 8776 A volume cannot be used as an M-VOL
when:
it is used by Continuous Access
Journal or Continuous Access Journal
Z.
it is used by Business Copy Z or
Compatible FlashCopy.
6005 8777 Combination of MCU with RCU
controller type is not supported.
6005 8778 One side of the Cache or shared
memory on the RCU is blocked.
6005 8779 Continuous Access Synchronous is not
supported under the RCU controller type.
6005 8780 Continuous Access Synchronous Z
function is not installed in the specified
controller.
6005 8781 Continuous Access Synchronous Z
function is not installed in the specified
controller.
6005 8785 The M-VOL is defined as the expansion
volume.
6005 8786 The R-VOL is defined as the expansion
volume.
6005 8788 The specified expanded volume in the
RCU is not defined.
6005 8789 Combination of the specified expansion
volumes is not valid.
6005 8790 The specified expansion volume
(Port/GID/LUN) of the RCU is not
usable.
6005 8791 The specified M-VOL is still online from
another HOST.
6005 8792 The operation failed because the Volume
Retention function was not installed in
the specified RCU.
Install Volume Retention, and retry the
operation.
6005 8793 The Continuous Access Synchronous
function is not installed in the specified
controller(s).
6005 8794 The Continuous Access Synchronous
function is not installed in the specified
controller(s).
Recommended Action
Select another volume.
Check the controller type of the specified
MCU and RCU, then contact HP
Technical Support.
There is an invalid cache or shared
memory status on the RCU. Check the
status and recover the cache or shared
memory, then retry the operation.
Confirm the controller type of the RCU.
Install the Continuous Access
Synchronous Z in the MCU and the RCU.
Install the Continuous Access
Synchronous Z in the MCU and the RCU.
Check the volume again.
Check the volume again.
Check the Port, GID and LUN settings of
the RCU.
The combination of the specified volumes
for LUN Expansion is not valid. Verify
the parameters and retry the operation.
Confirm the status of the specified
expansion volume and microcode
version of the RCU.
Vary the concerned path offline from the
other host, then retry the operation.
Install the Volume Retention in the MCU
and the RCU, then retry the operation.
Install Continuous Access Synchronous
in the MCU and the RCU, then retry the
operation.
Install Continuous Access Synchronous
in the MCU and the RCU, then retry the
operation.
Severity
Level
W
W
E
W
W
W
W
W
W
W
W
W
W
W
W
Part code 6005 141