HP StorageWorks P9000 - Disk Arrays Manual page 159

Table 52 Error codes (part code 6010) (continued)
Part Error Error Message
Code Number
6010 7302 An error occurred in the client logic.
6010 7303 An error occurred in the client logic.
6010 7440 An error occurred during processing. If
this problem persists, please contact HP
Technical Support.
6010 8101 The system cannot apply the new
configuration. Do you want to refresh?
6010 8928 An error occurred when copying started.
Do you want to recover from the error
condition?
6010 9006 Exchange the channel cable connections
after confirmation of the port type.
6010 9007 Please confirm that the R-VOLs to specify
are varied off-line.
6010 9008 SIMs of Remote Copy are cleared.
6010 9009 The export is complete.
6010 9021 The Port Setting process has not
completed. Do you want to continue for
other ports?
6010 9022 WARNING: Initial copy mode 'None'
is selected for some volume pairs. Are
you sure that the M-VOL and the R-VOL
of these pairs are already synchronized?
6010 9024 Are you sure you want to exchange the
specified ports? Please confirm the
associated channel paths are off-line.
6010 9025 Are you sure you want to switch the
ports? If the remote copy paths exist on
the ports, delete them beforehand.
6010 9026 Are you sure you want to switch the
ports? If any remote copy paths exist on
the ports, delete them beforehand. Also,
to avoid the switching operation from
being reported as a failure, confirm first
that a message prompting you to change
the channel cable connections is
displayed, and then perform the
necessary changes.
6010 9070 Are you sure you want to delete the
specified RCUs?
6010 9071 Are you sure you want to delete the
paths of a specified RCU?
6010 9072 Are you sure you want to delete the
specified volume pairs?
Recommended Action
Please contact HP Technical Support.
Please contact HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Click [Refresh], and retry.
Click [Yes] to recover from the error
condition. If not, click [No].
If the recovery fails despite retrying,
suspend the corresponding pair
temporarily, and execute Resume Pair
(Pairresync) operation.
Follow the instructions in the message.
Confirm that the R-VOLs to specify are
varied off-line.
Click [OK].
Click [OK].
Click [Yes] to continue processing. After
processing is complete, reset the port
that is not in operation.
Check the contents of the main and
remote volumes. If the contents match,
click [OK]. If not, click [Cancel].
Follow the instructions in the message.
To continue the operation, click [OK].
Otherwise, click [Cancel].
To continue the operation, click [OK].
Otherwise, click [Cancel].
To delete the specified RCU, click [OK].
Otherwise, click [Cancel].
To delete the specified path, click [OK].
Otherwise, click [Cancel].
To delete the specified pair, click [OK].
Otherwise, click [Cancel].
Severity
Level
E
E
E
W
W
i
i
i
i
i
i
i
i
i
W
W
W
Part code 6010 159