HP StorageWorks P9000 - Disk Arrays Manual page 144

Table 50 Error codes (part code 6005) (continued)
Part Error
Code Number
6005 8829
6005 8830
6005 8831
6005 8832
6005 8833
6005 8834
6005 8835
6005 8836
6005 8837
6005 8838
6005 8839
6005 8840
6005 8841
6005 8842
144 Message (part code group 6nnn)
Error Message
The LCP of the RCU cannot access the
specified R-VOL.
The specified M-VOL is already used as
a reserved volume of Auto LUN.
The specified R-VOL is already used as
a reserved volume of Auto LUN.
Please wait a few minutes and retry the
Add Pair (Paircreate) / Resume Pair
(Pairresync) operation.
Please wait a few minutes and retry the
Add Pair (Paircreate) / Resume Pair
(Pairresync) operation.
The Add Pair (Paircreate) operation
failed because you tried to create volume
pairs which exceeded the licensed
capacity.
The Add Pair (Paircreate) operation
failed because you tried to create volume
pairs which exceeded the licensed
capacity of the RCU side.
No additional volume pairs waiting for
copy.
An internal error occurred.
Specified volume is not part of a Remote
Copy pair.
Invalid RCU serial number, SSID, Link
Address or Controller ID.
Suspend(Pairsplit-r) operation is not valid
for R-VOL.
The specified volume is not a R-VOL.
R-VOL status change failed after M-VOL
status change. Confirm R-VOL status.
Recommended Action
Take the following actions:
Specify only one CU# for the same LCP
of the RCU.
Connect to the LCP that can access the
specified R-VOL.
Check the status of the specified M-VOL
(P-VOL) from HOST or SVP.
Check the status of the specified R-VOL
(S-VOL) from HOST or SVP.
Check the status of the specified M-VOL
(P-VOL), then retry the Add Pair
(Paircreate) / Resume Pair (Pairresync)
operation in a few minutes.
Check the status of the specified R-VOL
(S-VOL), then retry the Add Pair
(Paircreate) / Resume Pair (Pairresync)
operation in a few minutes.
See the license key and confirm the
licensed capacity of the volumes. To
create more pairs, purchase a license
key that allows you to use a larger
capacity.
See the license key of the RCU side, and
confirm the licensed capacity of the
volumes. To create more pairs, purchase
a license key that allows you to use a
larger capacity.
Check the pair status and retry.
Please contact HP Technical Support.
The specified volume is not part of a
Continuous Access Synchronous pair.
Check the volume.
Check the serial number, SSID, link
address and controller ID of the RCU,
and set the correct value. Then retry the
operation. If the same error occurs,
please contact HP Technical Support.
Suspend mode is not valid for the R-VOL.
Check the volume, and retry.
Refresh the window, and check whether
the specified volume is a R-VOL.
Confirm the R-VOL status.
Severity
Level
W
W
W
W
W
W
W
W
E
W
W
W
W
W