HP StorageWorks P9000 - Disk Arrays Manual page 61

Table 26 Error codes (part code 01022) (continued)
Part Error Error Message
Code Number
01022 105012 Invalid characters are used in the
specified host group name. You cannot
use the following characters:
\/:,;*?"<>|.
01022 105013 The specified host group name is already
used by another host group, which is on
the same port.
01022 105014 The default host group name cannot be
used for the host group setting.
01022 105015 Host mode "4C" is set to the host group.
However, this host group is connected
to a volume that cannot be used for
External Storage.
01022 105016 Detail button pressing detection without
line selection.
01022 105017 The Detail button pressing is detected by
two or more-line selection.
01022 105018 Multiple host groups are selected on the
same port.
01022 105019 The specified port is neither Target nor
RCU Target.
01022 105020 Hosts cannot be added because none
of [Available Hosts] table rows is
selected.
01022 105021 No more HBA WWN can be registered,
because the number of registered HBA
WWNs has reached the maximum.
01022 105022 The selected information cannot be
added, because a duplicated HBA
WWN is in the information being
selected.
01022 105023 The selected information cannot be
added because a duplicated host name
is in the information being selected.
01022 105024 The specified HBA WWN cannot be
added because it is already used in the
same port, or it exists in the [Selected
Hosts] table.
01022 105025 The specified host name cannot be
added because it is already used in the
same port, or it exists in the [Selected
Hosts] table.
01022 105026 The processing cannot be done because
of no data in the [Selected Hosts] table.
Recommended Action
Remove the invalid characters, then retry.
Specify another host group name.
Specify another host group name.
Check the setting(s).
Select one table row.
Select one table row.
Check the setting(s).
Check the setting(s).
Select one or more table rows.
Check the setting(s).
Only the first duplicate item is added.
Check the contents that have been
added.
Only the first duplicate item is added.
Check the contents that have been
added.
Check the setting(s).
Check the setting(s).
Check if there is a target host to be set
in the [Selected Hosts] table. When there
is not, add host(s) and retry the
operation. When there is, close the
window(s) and refresh it, then retry
again. If the same problem persists
despite retrying, please contact HP
Technical Support.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
Part code 01022 61