HP StorageWorks P9000 - Disk Arrays Manual page 236

Table 59 Error codes (part code 7005) (continued)
Part Error
Code Number
7005 68750
7005 68755
7005 68760
7005 68808
7005 68809
7005 68810
7005 68814
7005 68835
7005 68836
7005 68837
7005 68838
7005 68839
236 Message (part code group 7nnn)
Error Message
The Quick Restore command has been
rejected, because the specified pair is
composed of the Thin Provisioning
volume and the volumes other than Thin
Provisioning volume.
The Quick Restore command has been
rejected, because device information
(Inquiry information) of P-VOL and S-VOL
was different in the specified pair.
Quick Restore cannot be executed,
because the configuration is being
backed up in the target volume. Please
wait for a while, then retry the operation.
The command has been rejected,
because the specified P-VOL is a Thin
Provisioning volume whose capacity is
being added.
The command has been rejected,
because the specified S-VOL is a Thin
Provisioning volume whose capacity is
being added.
The command has been rejected,
because the specified reserved volume
is a Thin Provisioning volume whose
capacity is being added.
The Initialize function cannot be
executed, because a Continuous Access
Synchronous pair or a Continuous
Access Journal pair is created by using
Thin Provisioning volumes.
The command has been rejected,
because the specified P-VOL is used by
a pair of Snapshot, which is registered
in the CTG.
The command has been rejected,
because the specified S-VOL is used by
a pair of Snapshot, which is registered
in the CTG.
The command has been rejected,
because the specified P-VOL is a volume
of Thin Provisioning whose zero data is
being discarded.
The command has been rejected,
because the specified S-VOL is a volume
of Thin Provisioning whose zero data is
being discarded.
The command has been rejected,
because the specified reserved volume
is a volume of Thin Provisioning whose
zero data is being discarded.
Recommended Action
Quick Restore cannot be executed by
the current pair configuration.
Quick Restore cannot be executed in the
current pair configuration. Select a pair
where the device information (Inquiry
information) is the same, and execute
Quick Restore.
Wait for a while, then retry the
operation.
The operation is not available because
the target volume has capacity changes.
Check the capacity of the volume and
retry the setting.
The operation is not available because
the target volume has capacity changes.
Check the capacity of the volume and
retry the setting.
Confirm the capacity of the volume and
retry the setting.
Delete the Continuous Access
Synchronous pair or Continuous Access
Journal pair that is using Thin
Provisioning volumes, then retry the
operation.
Release the pair of Snapshot that is using
the specified P-VOL, then retry the
operation.
Release the pair of Snapshot that is using
the specified S-VOL, then retry the
operation.
Wait until the process of discarding zero
data is completed, then retry the
operation.
Wait until the process of discarding zero
data is completed, then retry the
operation.
Wait until the process of discarding zero
data is completed, then retry the
operation.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W