HP StorageWorks P9000 - Disk Arrays Manual page 273

Table 71 Error codes (part code 8505) (continued)
Part Error Error Message
Code Number
8505 55033 The same port is already registered in a
different SLPR.
8505 55228 This function is not available.
Open System Array Management is
required to create CLPR.
8505 56501 The login information of the partition
management function has been
initialized due to detection of conflicting
information. Please contact the storage
administrator. (To the storage
administrator: Please reconfigure the
login information.)
8505 56502 The operation to set the maximum
number of connections has been
cancelled because an attempt has been
made to specify this value to less than
the number of users who are currently
connected. Check the maximum
permissible number of connections.
8505 56524 This function cannot be used by the
storage partition administrator.
8505 56527 While another user is logged into
Remote Web Console, you cannot edit
the information of the SLPR that the user
owns. SLPR No:%s
8505 56536 The licensed capacity was exceeded
because of changing the configuration.
Please correct the licensed capacity on
the License Key Partition Definition panel.
8505 57002 An unknown error was detected.
8505 58310 Some of the shared memory of the disk
subsystem may be blocked, or the disk
subsystem is being maintained. Check
the status of the disk subsystem. If this
problem persists, please contact HP
Technical Support.
8505 5831 1 Some of the cache memory of the disk
subsystem may be blocked, or the disk
subsystem is being maintained. Check
the status of the disk subsystem. If this
problem persists, please contact HP
Technical Support.
8505 58312 The configuration cannot be changed
because the write pending rate of the
intended CLPR is too high. Please wait
until the write pending rate falls, and
then retry the operation.
Recommended Action
Please contact HP Technical Support.
Install the program product.
Please contact the storage administrator.
(To the storage administrator:
Reconfigure the login information.) If this
problem persists, please contact HP
Technical Support.
The operation to set the maximum
number of connections has been
cancelled because an attempt was made
to specify a value that is less than the
number of users who are currently
connected. Check the maximum
permissible number of connections.
Please contact HP Technical Support.
Please contact HP Technical Support.
Please contact HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Wait until the write pending rate falls,
then retry the operation.
Severity
Level
E
W
i
W
E
E
W
E
W
W
W
Part code 8505 273