HP StorageWorks P9000 - Disk Arrays Manual page 215

Table 56 Error codes (part code 6610) (continued)
Part Error Error Message
Code Number
6610 59004 An error occurred. Please check the error
details.
6610 59005 An invalid value is specified.
6610 59006 No more journal volumes can be
registered, or too many volumes are
selected.
6610 59007 Are you sure you want to delete the
specified subsystems?
6610 59008 Are you sure you want to delete the
paths of the specified subsystem?
6610 59009 Since the number of Preview data
exceeded the maximum, the excess data
were discarded. No more Preview data
can be stored.
6610 59010 WARNING:
Initial copy mode "None" is selected for
some volume pair. Are you sure that the
primary data volume and the secondary
data volume of the pair are already
synchronized?
6610 5901 1 Are you sure you want to output the %s
file?
6610 59013 The specified file already exists. Do you
want to overwrite this file?
6610 59026 The same DKC is specified more than
once. Check the DKC setting.
6610 59030 The monitoring data saved at present
will be deleted.
6610 59031 The monitoring data saved at present
will be deleted when the monitoring
switch is set to Enable the next time.
6610 59040 You cannot add journal volumes because
Continuous Access Journal Z is not
installed.
Recommended Action
Check the error information.
Specify the valid value.
Check the number of journal volumes in
the specified journal group, or check the
number of the selected volumes.
To delete the specified storage system,
click [OK]. Otherwise, click [Cancel].
To delete the specified path, click [OK].
Otherwise, click [Cancel].
Click [OK]. Apply the Preview data to
the disk storage system, then retry the
operation.
Check the contents of the primary and
secondary volumes. If the contents match,
click [Yes]. Otherwise, click [No].
To output the file, click [Yes]. Otherwise,
click [No].
To overwrite the file, click [Yes].
Otherwise, click [No].
Check the DKC setting.
To continue the operation, click [OK]. To
cancel the operation, click [Cancel].
The current monitoring data will be
deleted if you change the setting of the
monitoring switch. If necessary, use the
Performance Monitor Export Tool to
export the monitoring data file.
To continue processing, click [OK]. To
stop processing, click [Cancel].
The monitoring data currently saved will
be deleted when you change the setting
of the monitoring switch. If necessary,
use the Export Tool to save the
monitoring data.
Purchase a license for Continuous Access
Journal Z, then install it.
Severity
Level
W
W
W
W
W
i
i
i
W
W
W
i
W
Part code 6610 215