HP StorageWorks P9000 - Disk Arrays Manual page 171

Table 53 Error codes (part code 6505) (continued)
Part Error Error Message
Code Number
6505 8819 The specified secondary data volume
must not be:
in an intervention-requested condition
in a protected condition
in an unusable condition
a Business Copy S-VOL or a Business
Copy Z T-VOL
a volume reserved by Business Copy
or Business Copy Z
a volume used by Auto LUN
a Business Copy P-VOL in Swap or
Reverse Copy status
a Business Copy Z S-VOL in Swap or
Reverse Copy status
6505 8822 An I/O error occurred on the secondary
data volume.
6505 8830 The specified primary data volume is
already reserved by Auto LUN.
6505 8831 The specified secondary data volume is
already reserved by Auto LUN.
6505 8832 Please wait a few minutes and then retry
the operation.
6505 8833 Please wait a few minutes and then retry
the operation.
6505 8834 The Add Pair (Paircreate) operation
failed because you tried to create volume
pairs which exceeded the licensed
capacity.
6505 8835 The Add Pair (Paircreate) operation
failed because you tried to create volume
pairs which exceeded the licensed
capacity of the secondary subsystem.
6505 8887 An internal error occurred.
6505 8888 An internal error occurred.
6505 8889 The specified port is not equipped.
6505 8890 The specified port is being initialized.
6505 8891 Logical paths exist on the port.
Recommended Action
Check the status of the secondary data
volume.
Check the SSB log, then contact HP
Technical Support.
Volumes reserved by Auto LUN cannot
be specified as primary data volumes.
Check the status of the specified primary
data volume from the host or the SVP.
Volumes reserved by Auto LUN cannot
be specified as secondary data volumes.
Check the status of the specified
secondary data volume from the host or
the SVP.
Wait a few minutes and retry the
operation.
Wait for a few minutes and retry the
operation.
See license key information and check
the licensed volume capacity. To create
more pairs, please purchase a license
key for using larger capacity.
See the license key at the secondary
storage system and check the licensed
capacity of volumes. To create more
pairs, please purchase a license key for
larger capacity.
Check the SSB log, then contact HP
Technical Support.
Check the SSB log, then contact HP
Technical Support.
Refresh the window, and retry the
operation. If nothing changes, please
contact HP Technical Support.
Wait until the initialization of the port
ends, and retry the operation.
Delete the logical paths on the port and
retry the operation.
Severity
Level
W
E
W
W
W
W
W
W
E
E
W
W
W
Part code 6505 171