HP StorageWorks P9000 - Disk Arrays Manual page 208

Table 55 Error codes (part code 6510) (continued)
Part Error
Code Number
6510 59008
6510 59009
6510 59010
6510 5901 1
6510 59013
6510 59026
6510 59030
6510 59031
6510 59039
6510 59042
6510 59043
208 Message (part code group 6nnn)
Error Message
Are you sure you want to delete the
paths of the specified subsystem?
Since the number of Preview data
exceeded the maximum, the excess data
were discarded. No more Preview data
can be stored.
WARNING:
Initial copy mode "None" is selected for
some volume pair. Are you sure that the
primary data volume and the secondary
data volume of the pair are already
synchronized?
Are you sure you want to output the %s
file?
The specified file already exists. Do you
want to overwrite this file?
The same DKC is specified more than
once. Check the DKC setting.
The monitoring data saved at present
will be deleted.
The monitoring data saved at present
will be deleted when the monitoring
switch is set to Enable the next time.
You cannot add journal volumes because
Continuous Access Journal is not
installed.
There are no valid journals.
The number of journal volumes in some
journals exceeds the maximum.
Adjust the number of journal volumes.
Recommended Action
To delete the specified path, click [OK].
Otherwise, click [Cancel].
Click [OK]. Apply the Preview data to
the disk storage system, then retry the
operation.
Check the contents of the primary and
secondary volumes. If the contents match,
click [Yes]. Otherwise, click [No].
To output the file, click [Yes]. Otherwise,
click [No].
To overwrite the file, click [Yes].
Otherwise, click [No].
Check the DKC setting.
To continue the operation, click [OK]. To
cancel the operation, click [Cancel].
The current monitoring data will be
deleted if you change the setting of the
monitoring switch. If necessary, use the
Performance Monitor Export Tool to
export the monitoring data file.
To continue processing, click [OK]. To
stop processing, click [Cancel].
The monitoring data currently saved will
be deleted when you change the setting
of the monitoring switch. If necessary,
use the Export Tool to save the
monitoring data.
Purchase a license for Continuous Access
Journal, then install it.
All journals are used by Continuous
Access Journal Z or Continuous Access
Journal. If possible, delete the journals
for Continuous Access Journal Z or
Continuous Access Journal, then start the
Continuous Access Journal Z window or
the Continuous Access Journal window.
Reduce the number of journal volumes
to be registered, or increase the number
of journal volumes to be deleted.
Severity
Level
W
i
i
i
W
W
W
i
W
W
W