Part Code 7105 - HP StorageWorks P9000 - Disk Arrays Manual

Part code 7105

Table 62 Error codes (part code 7105)
Part Error
Code Number
7105 5099
7105 5625
7105 5626
7105 6502
7105 6503
7105 6520
7105 7310
7105 8500
7105 8501
7105 8502
7105 8503
7105 8504
7105 8505
7105 8506
Error Message
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
An internal logic error occurred.
The specified volume cannot be used
because it is write-protected by Volume
Retention.
Processing in progress. Please wait for
a while, and then retry the operation.
The volume status is being changed to
simplex.
The command has been rejected,
because the specified volume was
registered in the Security Group that
cannot specify T-VOL or reserved volume.
This error code is not registered.
Sufficient amount of shared memory is
not installed or the program product is
not installed.
The command has been rejected,
because the command specified last time
is being processed.
You cannot reserve the volume, because
a remote copy pair exists in the same
subsystem frame.
You cannot create the new pair, because
a remote copy pair exists in the same
subsystem frame.
The command was rejected. Check the
composition, the status, or the volume
status of the pair.
The command has been rejected,
because the operation cannot be
accepted in the current pair status.
The command has been rejected,
because the specified T-VOL or reserved
volume is used by the host.
Recommended Action
If this problem persists, please contact
HP Technical Support.
Please contact HP Technical Support.
Release the write-protection by Volume
Retention.
Wait a while, and retry the operation.
Wait a while, and retry the operation.
Execute one of the following:
Change the attribute of the Security
Group so that the Security Group can
specify T-VOL or reserved volume.
Remove the volume specified from the
Security Group.
If this problem persists, please contact
HP Technical Support.
Add shared memory or confirm whether
the necessary program product key is
installed.
Wait a while, and retry the operation.
Delete the Remote Copy pair.
Delete the Remote Copy pair.
Confirm the composition, the status, or
the volume status of the pair. (See the
Business Copy for Mainframe Systems
User Guide for the relation between the
composition of the pair, status of the
pair, or the volume status of the pair and
those operations.)
See the section "Status, permitted pair
operations" in the Business Copy for
Mainframe Systems User Guide for the
relation between the status of pairs and
the commands that can be accepted.
Vary the T-VOL or the reserved volume
offline from the mainframe host, then
issue the command again.
Severity
Level
E
W
W
W
W
W
E
W
W
W
W
W
E
W
Part code 7105 241