HP StorageWorks P9000 - Disk Arrays Manual page 87

Table 31 Error codes (part code 3005) (continued)
Part Error Error Message
Code Number
3005 78029 The frequency distribution data cannot
be obtained. There is no monitoring
information (VOL creation).
3005 78030 The frequency distribution data cannot
be obtained. There is no monitoring
information (HDEV SWAP or Cnt Ac-S
initial copy occurs).
3005 78031 The specified Processor Blade has been
blockaded.
3005 78032 The specified Processor Blade is not
mounted.
3005 78034 The specified POOL ID or the LDEV ID
does not exist.
3005 78035 The frequency distribution data cannot
be obtained. There is no monitoring
information (SM depletion).
3005 78036 The specified logical volume is already
in the normal status.
3005 78037 The pool is blocked.
3005 78038 The specified POOL ID or the LDEV ID
is not for Smart Tiers use.
3005 78039 The DKC is set to the state of
suppression of pool shrinking.
3005 78040 The storage system is set to the state of
suppression of tier relocation starting.
3005 78041 The operation cannot be executed
because the specified pool is now in
zero data page discarding process.
3005 78042 The operation cannot be executed
because the pool where the Thin
Provisioning Volume belongs to is now
in pool shrinking or tier relocation
process.
3005 78043 The operation cannot be executed
because the specified pool has
following problems.
3005 78044 The operation cannot be executed
because the specified pool has one of
the following problems.
The pool usage exceeds the
threshold.
The pool status is invalid.
The status of the specified Pool-VOL
is not normal.
The I/O load of the V-VOL
associated with the specified pool
is high.
Recommended Action
Collect the information, then retry the
operation.
Collect the information, then retry the
operation.
Recover the blocked Processor Blade,
then specify it.
Check the specified Processor Blade.
Click [Refresh], then check the
configuration information again.
Check the total capacity of Thin
Provisioning volumes, then retry the
operation.
Check the logical volume status, then
retry the operation.
Recover the pool.
Check the configuration information.
Please contact HP Technical Support.
Please contact HP Technical Support.
Wait until the zero data pages are
discarded, or abort it.
Wait until the pool is shrunk or the tier
is relocated, or abort it.
Verify the following items, and then retry
the operation.
The threshold value of the pool.
The pool status.
Execute any of the following actions,
then retry the operation.
If this problem persists, please contact
HP Technical Support.
Restore the Pool-VOL to the normal
status.
Reduce the I/O load of the V-VOL.
Severity
Level
W
W
W
W
W
W
W
W
W
E
E
W
W
E
E
Part code 3005 87