HP StorageWorks P9000 - Disk Arrays Manual page 73

Table 29 Error codes (part code 2005) (continued)
Part Error Error Message
Code Number
2005 1925 The combination order of LUSE volume
is incorrect.
2005 2005 An error occurred during SVP
processing.
2005 2009 An error occurred during SVP
processing.
2005 2013 An error occurred during SVP
processing.
2005 2015 An error occurred while connecting to
the storage system.
2005 2032 An error occurred while connecting to
the storage system.
2005 2082 Processing is disabled because the host
is mounted or the device is reserved.
2005 2083 The subsystem status is invalid.
2005 2084 The subsystem status is invalid.
2005 2098 The operation cannot be performed,
because the SVP microcode version does
not match the DKCMAIN (subsystem)
microcode version.
2005 2099 The operation cannot be performed,
because an inoperative Processor exists.
2005 2502 The specified volume cannot be
combined as a LUSE volume because it
is not Read/Write attribute (S-VOL
enabled).
2005 2503 The LUSE volume cannot be released
because the attribute of the specified
volume is not Read/Write (S-VOL
enabled).
2005 3002 An error occurred during SVP
processing.
2005 3003 An error occurred during SVP
processing.
2005 3006 An error occurred during SVP
processing.
2005 5013 An error occurred during SVP
processing.
2005 6012 An error occurred during SVP
processing.
Recommended Action
Check the settings.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If the same error occurs despite retrying,
please contact HP Technical Support.
If the same error occurs despite retrying,
please contact HP Technical Support.
Unmount the host and cancel reservation
of the device. If the host is an AIX host,
unmount the host, and execute the
varyoffvg command.
Check the DKC status and the current
status of the configuration setting. If
necessary, re-execute the setting
operation.
Check the DKC status and the current
status of the configuration setting. If
necessary, re-execute the setting
operation.
Please contact HP Technical Support ,
when the same problem persists.
Wait a while, then retry the operation.
If the same problem persists, please
contact HP Technical Support.
Correct settings, then retry.
Correct settings, then retry.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Severity
Level
W
E
E
W
W
W
W
W
W
E
W
W
W
E
E
E
E
E
Part code 2005 73