HP StorageWorks P9000 - Disk Arrays Manual page 290

Table 85 Error codes (part code 9605) (continued)
Part Error
Code Number
9605 8128
9605 8132
9605 8134
9605 8135
9605 8136
9605 8138
9605 8139
9605 8141
9605 8142
9605 8150
9605 8151
9605 8152
9605 8153
9605 8154
9605 8155
9605 8156
9605 58404
9605 58412
9605 58413
9605 58414
290 Message (part code group 9nnn)
Error Message
A parameter error occurred.
This error code is not registered.
The attribute of this logical volume
cannot be changed to Read/Write.
This logical volume is already used as
an S-VOL for Remote Copy or Business
Copy.
The command was rejected, because the
licensed capacity was exceeded.
The Reserved setting of the specified
volume cannot be released.
The specified volume is a P-VOL for
Business Copy.
This logical volume cannot be selected
because it is used as a reserve volume
for Auto LUN.
You cannot select this logical volume
because it is used as a Continuous
Access Journal volume.
You tried to set a retention term to a
logical volume whose access attribute is
not Read Only or Protect.
The retention term of the logical volume
cannot be shortened.
You cannot set a retention term to any
mainframe volumes.
The specified retention term exceeds the
maximum.
The retention term of the logical volume
has been changed by RAID Manager.
You cannot change the access attribute
because a retention term is set to the
specified logical volume.
You cannot change the access attribute
because the expiration lock is set to
Enable.
The specified operation cannot be
executed because the LDEV shredding
or the LDEV format is being executed.
The attribute of the pool volume cannot
be changed.
The attribute of the virtual volume of the
Snapshot cannot be changed.
The attribute of the P-VOL or the S-VOL
of the Snapshot cannot be changed.
Recommended Action
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
To change the attribute, please contact
HP Technical Support.
Check the logical volume configuration,
then retry the operation.
The currently licensed capacity is
insufficient. To increase the licensed
capacity, buy a new license key.
To release the Reserved setting, please
contact HP Technical Support.
Check the volume, then retry the
operation.
Check the volume, then retry the
operation.
Check the logical volume, then retry the
operation.
Check the logical volume, then retry the
operation.
To shorten it, please contact HP
Technical Support.
Specify an open-systems volume.
Correct the retention term, then retry the
operation.
Check the retention term of the logical
volume, then retry the operation.
To change the access attribute of the
logical volume to Read/Write, please
contact HP Technical Support.
Set the expiration lock to Disable, then
change the access attribute.
Retry the operation after the process is
completed.
Select another volume.
Select another volume.
Select another volume.
Severity
Level
E
E
E
W
W
E
W
W
W
W
W
W
W
W
W
W
W
W
W
W