HP StorageWorks P9000 - Disk Arrays Manual page 229

Table 59 Error codes (part code 7005) (continued)
Part Error Error Message
Code Number
7005 8619 The specified S-VOL is defined as a
source volume for Auto LUN.
7005 8622 The command has been rejected,
because the specified volume is used as
P-VOL of Continuous Access Synchronous
pair.
7005 8623 The command has been rejected,
because the specified volume is used as
S-VOL of Continuous Access Synchronous
pair.
7005 8624 The command has been rejected,
because there is no pair to be operated.
7005 8625 The P-VOL(S-VOL) and S-VOL(T-VOL)
have the same number.
7005 8626 The SMPL command was rejected,
because the high-speed Split was in
progress.
7005 8627 The Pairresync operation has been
rejected, because pair status is
COPY(SP).
7005 8628 The operation of the L1 pair failed
because the L2 pair was in COPY(SP)
status or PSUS(SP) status.
7005 8629 The status mode specification is invalid.
7005 8630 The status mode type is invalid.
7005 8631 The specified CU number is invalid.
7005 8632 The timing of issuing the command is
invalid.
7005 8633 The abnormal status is invalid.
7005 8634 The volume specified as a reserved
volume is already defined as a reserved
volume for Auto LUN.
7005 8635 The specified P-VOL is defined as a
reserved volume for Auto LUN.
7005 8636 The specified S-VOL is defined as a
reserved volume for Auto LUN.
7005 8637 The specified P-VOL is used as a source
volume for Auto LUN.
7005 8638 The command has been rejected,
because the specified P-VOL is set for
use in Cache Residency.
7005 8639 The command has been rejected,
because the specified S-VOL is set for
use in Cache Residency.
Recommended Action
Release the Auto LUN setting.
The P-VOL of Continuous Access
Synchronous pair cannot be used as a
reserved volume.
Specify another volume.
The S-VOL of Continuous Access
Synchronous pair cannot be used as a
reserved volume.
Specify another volume.
Confirm whether the volumes specified
for P-VOL and S-VOL are correct or not.
Check the specified volume number.
After the high-speed Split is completed,
retry the operation.
Wait until the status of the pair changes
to PSUS.
Wait until the L2 pair status changes to
PSUS, then retry the operation.
Check the contents, and retry.
Check the contents, and retry.
Please contact HP Technical Support.
Please contact HP Technical Support.
Please contact HP Technical Support.
Specify other volume(s), or release the
Auto LUN Setting.
Specify other volume(s), or release the
Auto LUN Setting.
Specify other volume(s), or release the
Auto LUN Setting.
Specify other volume(s), or release the
Auto LUN setting.
You cannot execute the specified
operation. Release the Cache Residency
setting for the operation.
You cannot execute the specified
operation. Release the Cache Residency
setting for the operation.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
E
E
W
W
W
W
W
W
Part code 7005 229