HP StorageWorks P9000 - Disk Arrays Manual page 242

Table 62 Error codes (part code 7105) (continued)
Part Error
Code Number
7105 8507
7105 8508
7105 8509
7105 8510
7105 851 1
7105 8512
7105 8513
7105 8514
7105 8515
7105 8516
7105 8517
7105 8518
7105 8519
7105 8520
7105 8521
7105 8522
7105 8523
7105 8524
7105 8525
7105 8526
7105 8527
7105 8528
242 Message (part code group 7nnn)
Error Message
The Split Pair command was issued to
the pairs in the split status.
The AddPair command was issued to the
pairs in the Split status.
The Split command with the QUIESCE
specification was issued to a secondary
boot device.
The M-VOL Suspend command was
issued to a secondary boot device.
You cannot reserve the volume, because
a path group is set.
Cannot perform Resync or Suspend
operation because of the path group
setting.
The command has been rejected,
because the specified S-VOL is used by
the host.
No reserved volume can be allocated.
The number of cylinders in the reserved
volume exceeds the maximum.
The number of S-VOL cylinders exceeds
the maximum.
The number of T-VOL cylinders exceeds
the maximum.
You cannot create a pair, because the
track format is different for each. Make
sure that the specified emulation type is
the same for both.
You cannot set a pair because the
number of cylinders is different for each.
Make sure that the capacity is the same
for both.
You cannot set a pair, because the
volume type is different for each.
The number of multiple copy jobs
exceeded the maximum.
The emulation type of the S-VOL is not
supported.
The emulation type of the T-VOL is not
supported.
The emulation type is not supported.
An internal logic error occurred.
An internal logic error occurred.
An internal logic error occurred.
An internal logic error occurred.
Recommended Action
You cannot execute the Split Pair
operation because the pair is already in
the Split status.
You cannot execute the AddPair
operation to the pairs in the Split status.
Check the contents, and retry.
Check the contents, and retry.
Detach the S-VOL from the host, or delete
the Remote Copy path.
Detach the S-VOL from the host, or delete
the Remote Copy path.
Vary the S-VOL offline from the
mainframe host, then issue the command
again.
Delete the Reserve volume.
Check the contents, and retry.
Check the contents, and retry.
Check the contents, and retry.
Check the emulation type.
Check the volume capacity.
Specify the volume with the same
emulation type, and retry the operation.
Check the contents, and retry.
Specify the supported emulation type.
Specify the supported emulation type.
Specify the supported emulation type.
Please contact HP Technical Support.
Please contact HP Technical Support.
Please contact HP Technical Support.
Please contact HP Technical Support.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
E
E
E
E