HP StorageWorks P9000 - Disk Arrays Manual page 205

Table 55 Error codes (part code 6510) (continued)
Part Error Error Message
Code Number
6510 9024 Are you sure you want to exchange the
specified ports? Please confirm the
associated channel paths are off-line.
6510 9025 Are you sure you want to switch the
ports? If the remote copy paths exist on
the ports, delete them beforehand.
6510 9026 Are you sure you want to switch the
ports?
If any remote copy paths exist on the
ports, delete them beforehand.
Also, to avoid the switching operation
from being reported as a failure, confirm
first that a message prompting you to
change the channel cable connections
is displayed, and then perform the
necessary changes.
6510 9100 Do you want to exit?
6510 9101 Do you want to cancel?
6510 9102 Do you want to apply?
6510 9104 Do you want to change the mode?
6510 9105 The value that is under setup is not
reflected yet. Do you want to exit?
6510 9106 The value that is under setup is not
reflected yet. Do you want to change the
mode?
6510 9107 The value that is under setup is not
reflected yet. Do you want to continue
the operation?
6510 91 1 1 Do you want to delete the specified line
of settings from the Preview list?
6510 91 12 Do you want to continue this operation?
6510 91 15 The monitoring was stopped by another
operator. The graph will be closed.
6510 91 16 Another operator has changed the
Gathering Interval value. The graph will
be closed.
6510 91 17 Are you sure you want to close the
graph?
6510 91 18 Please check the specified value.
6510 91 19 No graph item has been selected. Please
select a graph item.
Recommended Action
Ensure that the associated channel paths
are offline.
Remove the remote copy paths that are
associated with the ports.
To continue to change ports, click [OK].
To close the window, click [OK].
Otherwise, click [Cancel].
To cancel the operation, click [OK].
To apply settings in Preview to the disk
storage system, click [OK].
To switch the mode, click [OK].
Otherwise, click [Cancel].
To discard the current settings and close
the window, click [OK]. Otherwise, click
[Cancel].
To discard the current settings and switch
to View mode, click [OK]. Otherwise,
click [Cancel].
To discard the current settings and
refresh the window, click [OK].
Otherwise, click [Cancel].
To discard the current settings, click
[OK]. Otherwise, click [Cancel].
To continue the current operation, click
[OK]. Otherwise, click [Cancel].
Click [OK].
Click [OK].
To close the graph, click [OK].
Otherwise, click [Cancel].
To apply this setting, click [OK]. If you
want to change the setting, click
[Cancel].
Select a graph item.
Severity
Level
i
i
i
i
i
i
i
W
W
W
W
i
i
i
W
i
W
Part code 6510 205