HP StorageWorks P9000 - Disk Arrays Manual page 38

Table 18 Error codes (part code 0405) (continued)
Part Error
Code Number
0405 7207
0405 8002
0405 8003
0405 8202
0405 8203
0405 8204
0405 8205
0405 8206
0405 8301
0405 55263
0405 55506
0405 55520
0405 56524
38 Message (part code group 0nnn)
Error Message
An error occurred during SVP
processing.
An error occurred during SVP
processing.
The subsystem status is invalid.
The DKCMAIN microcode does not
support this program product.
This program product needs a later
version of hardware. Please contact HP
Technical Support.
To use this program product, it is
required to enable the program product
by allocating additional shared memory.
Add cache memory in case of need.
This program product remains in the
configuration. Please contact HP
Technical Support.
This program product is in use, you
cannot remove this program.
The subsystem status is invalid.
The specified program product cannot
be removed, because the license for it is
allocated to the SLPR.
Since the licensed capacity of SLPR0 is
insufficient, the partition capacity can't
be increased.
It is not possible to install it because of
PP of pre-install.
This function cannot be used by the
storage partition administrator.
Recommended Action
If this problem persists, please contact
HP Technical Support.
Isolate the abnormal section following
the procedure below:
Rebooting the PC
Checking the LAN card/LAN cable
Checking the IP address of the PC
Replacing the PC
Turning on, then off the DKC (care
should be taken.)
Isolate the abnormal section following
the procedure below:
Rebooting the PC. If this does not fix the
problem:
Checking the LAN card/LAN cable. If
this does not fix the problem:
Checking the IP address of the PC. If this
does not fix the problem:
Replacing the PC. If a new PC does not
fix the problem:
Turn the DKC on, then off (care should
be taken.
Contact the Support Center for the plans
of the program product to be supported
by DKCMAIN.
Please contact HP Technical Support.
Allocate additional shared memory, and
enable the program product.
Please contact HP Technical Support.
Stop using this program product function.
Retry this operation.
If the same problem persists despite
retrying, please contact HP Technical
Support.
If the same problem persists despite
retrying, please contact HP Technical
Support.
If this problem persists, please contact
HP Technical Support.
If the same problem persists despite
retrying, please contact HP Technical
Support.
Severity
Level
E
E
E
E
E
E
E
W
E
E
E
E
E