HP StorageWorks P9000 - Disk Arrays Manual page 45

Table 21 Error codes (part code 0605) (continued)
Part Error Error Message
Code Number
0605 65796 The External Path Group specified as a
migration source has already been used
as a migration target.
0605 65797 The External Path Group specified as a
migration target has already been used
as a migration source.
0605 65798 The path configuration of the External
Path Group between the migration
source and the migration target is
different.
0605 65799 There are no setting lines of
NewPathGroup.
0605 65800 The number of NewPathGroup setting
lines exceeds the limit.
0605 65801 There are no setting lines of the ExG.
0605 65802 There are no setting lines of
TargetPathGroup.
0605 6601 1 The number of external LUs that can be
connected from a single port has
exceeded the maximum value.
0605 66012 The number of registered ports of the
external storage system has exceeded
the maximum.
0605 66013 The specified emulation type cannot be
set because 3390-3R is set in the storage
system.
0605 66014 The specified emulation type cannot be
set because 3390-3 is set in the storage
system.
0605 66501 The number of LDEVs that can be defined
in an external volume has exceeded the
maximum value.
0605 66502 Specified ExG has already been used.
0605 66503 LDKC, CU, and LDEV are not set within
the range where they can be used.
0605 66504 Specified LDKC:CU:LDEV has already
been used.
0605 66505 The specified LDEV number has already
been assigned to another emulation
group within the range grouped by 32
LDEV numbers.
0605 66506 Specified SSID has already been used.
0605 66507 The target external volume is blocked or
not set within the range of capacity that
can be used.
0605 66508 The specified LDEV capacity is invalid.
Recommended Action
Clear the duplicated setting, then retry
the operation.
Clear the duplicated setting, then retry
the operation.
Check the specified External Path Group.
Check the contents of the spreadsheet.
Check the contents of the spreadsheet.
Check the setting of ExG.
Check the contents of the spreadsheet.
Delete unnecessary external LU(s), then
retry the operation.
Operate within the ports of the
connected external storage system.
Change the emulation type to be set in
the volume.
Change the emulation type to be set in
the volume.
Check the number of LDEVs.
Check the setting of ExG.
Check the setting of LDKC, CU, and
LDEV.
Check the setting of LDKC, CU, and
LDEV.
Check the setting of emulation groups
within the range grouped by 32LDEV
numbers.
Check the setting of SSID.
Check the status and the capacity of
target external volume.
Check the setting of LDEV capacity.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
Part code 0605 45