Part Code 10122 - HP StorageWorks P9000 - Disk Arrays Manual

Part code 10122

Table 89 Error codes (part code 10122)
Part Error
Code Number
10122 105194
10122 105195
10122 105196
10122 105197
10122 105234
10122 105235
10122 105236
10122 105237
10122 105238
10122 105239
10122 105240
10122 105276
10122 106081
10122 106082
10122 106083
10122 106084
10122 106085
10122 106088
10122 107001
294 Message (part code group 10nnn)
Error Message
An error occurred while formatting.
An error occurred while preparing the
quick format.
The specified encryption key cannot be
deleted because it is not created.
The specified encryption key cannot be
deleted because it is encrypted.
The encryption key cannot be created to
the specified Key ID.
There is no parity group that is target to
release the encryption setting.
Encryption Key is not selected.
Format Type is not selected.
The value of Encryption Key is invalid.
There is no change on the Encryption
Key.
The selected parity group is not blocked.
The encryption cannot be set for the
specified parity group because it is for
an external volume.
The re-entered password does not match
the password which is entered
previously.
Operation cannot be done because a
task is in progress now.
A timeout error occurred.
The size of the specified file is too large.
The encryption key that has been
generated does not exist.
The LDEVs in a parity group where the
encryption key is set are not all blocked.
An internal logic error occurred.
Recommended Action
Retry the operation. If the same problem
persists despite retrying, please contact
HP Technical Support.
Retry the operation. If the same problem
persists despite retrying, please contact
HP Technical Support.
Release the selected encryption key that
is not created.
Specify another encryption key that is
not encrypted.
Specify the other Key ID.
Check the setting(s).
Check the setting(s).
Check the setting(s).
Check the setting(s).
Check the setting(s).
Check the setting(s).
Check the setting(s).
Check the setting(s).
Wait for a while, then retry the
operation. If the problem still persists,
close the window, then check the task
status.
If the problem persists despite retrying,
please contact HP Technical Support.
Check the specified file.
Check the configuration of the encryption
keys.
Block all LDEVs in the parity group where
the encryption key is set, then retry the
operation.
If the problem persists despite retrying,
please contact HP Technical Support.
Severity
Level
E
E
W
W
W
W
W
W
W
W
W
W
W
W
E
W
W
W
E