HP StorageWorks P9000 - Disk Arrays Manual page 161

Table 52 Error codes (part code 6010) (continued)
Part Error Error Message
Code Number
6010 9121 Data has been changed and the graph
has been displayed. If you continue this
operation, all the data and the graph
will become invalid. Are you sure you
want to continue this operation?
6010 9122 Are you sure you want to export pair
status?
6010 9124 This process may take up to %d minutes.
Do you want to continue?
6010 9125 Are you sure you want to cancel the
export?
6010 9126 The script is running now. Are you sure
you want to terminate the script?
6010 9127 Are you sure you want to close all active
graphs?
6010 9128 The specified volume was not found.
6010 9129 Recovered from the error that occurred
when copying started.
6010 9154 As a result of this operation, you will not
be able to re-start ERASE R-VOL
operation. To delete the pair forcibly,
please try again with 'Force' option.
6010 9155 The history file has been updated. Select
the OK button to display the history logs
from the beginning.
6010 9300 WARNING: Destination volume of
specified volume pair may contain some
inconsistency, because volume copy is
not completed yet. Full volume
initialization is required before re-using
it.
6010 9301 WARNING: Through this operation,
M-VOL status will be changed to SMPL
status forcibly, but R-VOL status will not
be changed. If you do this operation,
please change the R-VOL status to SMPL
later.
6010 9303 There are no valid volumes.
6010 9305 There are no initiator ports.
6010 9306 The Remote Copy function is not installed
in this controller. You cannot create
pairs.
6010 9307 You specified the same volumes more
than once. The duplicate occurrences
were excluded.
Recommended Action
To execute this operation, click [OK],
Otherwise, click [Cancel].
To output pair status into a snapshot file,
click [OK]. To cancel this operation, click
[Cancel].
To continue the operation, click [OK]. To
cancel the operation, click [Cancel].
To stop the operation, click [OK]. To
continue the operation, click [Cancel].
To terminate the script, click [OK].
Otherwise, click [Cancel].
To close the graphs, click [OK].
Otherwise, click [Cancel].
Click [OK], then specify the correct
volume.
Click [OK] to continue processing.
Follow the instructions in the message.
Click [OK].
Follow the instructions in the message.
Follow the instructions in the message.
Confirm whether the command device
for Business Continuity Manager is
defined.
Set the port to Initiator before registering
RCU.
There is no Remote Copy license. Set the
license.
Since the same volume where multiple
paths are defined was selected, the
overlapped one was eliminated. Click
[OK] and continue.
Severity
Level
W
i
i
W
W
W
W
i
i
i
i
i
W
W
W
W
Part code 6010 161