HP StorageWorks P9000 - Disk Arrays Manual page 213

Table 56 Error codes (part code 6610) (continued)
Part Error Error Message
Code Number
6610 91 16 Another operator has changed the
Gathering Interval value. The graph will
be closed.
6610 91 17 Are you sure you want to close the
graph?
6610 91 18 Please check the specified value.
6610 91 19 No graph item has been selected. Please
select a graph item.
6610 9120 The graph will be closed if you execute
the processing. Do you want to execute
the processing?
6610 9121 Data has been changed and the graph
has been displayed. If you continue this
operation, all the data and the graph
will become invalid. Are you sure you
want to continue this operation?
6610 9122 Are you sure you want to export pair
status?
6610 9127 Are you sure you want to close all active
graphs?
6610 9128 The specified volume was not found.
6610 9155 The history file has been updated. Select
the OK button to display the history logs
from the beginning.
6610 9303 There are no valid volumes.
6610 9305 There are no initiator ports.
6610 9306 The Continuous Access Journal Z function
is not installed in this controller. You
cannot create pairs.
6610 9308 You set the same path more than once.
The duplicate paths are excluded.
6610 9309 All paths which you set have already
been registered. This operation will
terminate because there is no path which
can be added.
6610 9327 The monitoring time is over, but the
history file is not fully updated yet.
6610 9332 This operation is not applied yet.
6610 55036 Too many data volumes in the journal.
Recommended Action
Click [OK].
To close the graph, click [OK].
Otherwise, click [Cancel].
To apply this setting, click [OK]. To
change the setting, click [Cancel].
Select a graph item.
To execute the processing and close the
graph, click [OK]. Otherwise, click
[Cancel].
To execute this operation, click [OK].
Otherwise, click [Cancel].
To export, click [OK].
To cancel the operation, click [Cancel].
To close the graphs, click [OK].
Otherwise, click [Cancel].
Click [OK], then specify the correct
volume.
Click [OK].
Click [OK], then specify the correct
volume.
Set the port to Initiator before registering
the storage system.
Obtain a license for Continuous Access
Journal Z, then install it.
Since there are duplicated paths in the
added paths, the duplicated paths will
be eliminated. Click [OK] to continue.
Since all the added paths are redundant,
the paths cannot be added. Click [OK]
and continue.
Click [Refresh] to update the history file.
If this problem persists, please contact
HP Technical Support.
Click [OK], then continue the operation.
Check the number of data volumes in the
journal. Then delete unused data volume
pairs, or register them in another journal.
Severity
Level
i
W
i
W
W
W
i
W
W
i
W
W
W
W
W
i
i
W
Part code 6610 213