HP StorageWorks P9000 - Disk Arrays Manual page 43

Table 21 Error codes (part code 0605) (continued)
Part Error Error Message
Code Number
0605 8102 This function is not supported.
0605 8122 Another maintenance processing is in
progress.
0605 8136 The command was rejected, because the
licensed capacity has exceeded the
maximum.
0605 8140 The configuration of Compatible
FlashCopy is defined.
0605 8958 An error occurred on the DKC side.
0605 8966 An error occurred on the DKC side.
0605 8979 The operation of the external volume has
been failed because all the paths to the
external volume are blocked.
0605 56513 An emulation type that cannot be added
is specified.
0605 56515 The Disconnect External Storage Systems
or the Disconnect External Volumes is not
executed for the target volume.
0605 56516 The configuration of Continuous Access
Synchronous or Continuous Access
Synchronous Z is defined.
0605 56517 The configuration of Business Copy,
Business Copy Z, or Snapshot is defined.
0605 56519 The reserved volume setting for Business
Copy or Business Copy Z is defined.
0605 56520 The reserved volume setting for Auto LUN
is defined.
0605 58258 All the paths to the external volume are
blocked.
0605 58263 No paths will be available, if you
change the setting of paths.
0605 58330 After executing the Disconnect External
Storage Systems or the Disconnect
External Volumes, neither the Reconnect
External Paths nor the Disconnect
External Paths can be executed.
0605 58331 The specified External Path is not
registered.
Recommended Action
Check whether the DKCMAIN microcode
version and the SVP microcode version
are mismatched.
Wait for a while, then retry the
operation.
Check the licensed capacity, then specify
it within the licensed capacity or add the
licensed capacity.
Release the configuration definition of
Compatible FlashCopy, then retry the
operation.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Restore more than one path to the
external volume, then perform the
operation of the external volume.
Check the emulation type. If you want to
change the cache segment size to set the
specified emulation type, please contact
HP Technical Support.
Execute the Disconnect External Storage
Systems or the Disconnect External
Volumes, then retry the operation.
Release the configuration definition of
Continuous Access Synchronous or
Continuous Access Synchronous Z, then
retry the operation.
Release the configuration definition of
Business Copy, Business Copy Z, or
Snapshot, then retry the operation.
Release the reserved volume setting for
Business Copy or Business Copy Z, then
retry the operation.
Release the reserved volume setting for
Auto LUN, then retry the operation.
Restore the blocked path status, then
retry the operation.
Make the setting of the paths to keep at
least one path available, then retry the
operation.
Execute the Reconnect External Storage
Systems or the Reconnect External
Volumes, then retry the operation.
Check the specified External Path.
Severity
Level
W
W
W
W
E
E
W
W
W
W
W
W
W
W
W
W
W
Part code 0605 43