HP StorageWorks P9000 - Disk Arrays Manual page 154

Table 50 Error codes (part code 6005) (continued)
Part Error
Code Number
6005 68027
6005 68757
6005 68758
6005 68764
6005 68787
6005 68789
6005 68791
6005 68793
6005 68794
6005 68795
6005 68796
6005 68812
6005 68813
6005 68816
154 Message (part code group 6nnn)
Error Message
The operation failed because the RCU
does not support the CU number, the
LDKC number or the LU number of the
specified M-VOL.
The Paircreate operation has failed
because the specified S-VOL, which is a
Thin Provisioning volume, is already used
by another program product.
The Add Pair(Paircreate) operation failed
because the specified R-VOL was a
System Disk.
The Add Pair(Paircreate) operation failed
because the specified M-VOL was a
System Disk.
The operation failed because the
Continuous Access Synchronous function
was not installed.
The Paircreate operation failed because
the Continuous Access Synchronous
function was not installed in the RCU.
The operation failed because the
specified volume was not an R-VOL.
The Reverse Resync operation failed
because the status of the specified
volume was not SSWS.
The operation failed because the path
from the RCU to the MCU did not exist.
The operation failed. The shared memory
might be insufficient.
Please contact HP Technical Support.
The operation failed. The operation
cannot be accepted in the pair status of
the specified volume.
A pair could not be created because the
specified R-VOL was a Thin Provisioning
volume whose capacity was being
changed.
A pair could not be created because the
specified M-VOL was a Thin Provisioning
volume whose capacity was being
changed.
A pair cannot be created because the
specified volume is used as a primary
data volume of the Continuous Access
Journal.
Recommended Action
Check the CU number, the LDKC
number, or the LU number of the
specified M-VOL.
Select another volume that is not used
by other program products such as
Business Copy/Snapshot, and Auto LUN,
or cancel the use of the volume operated
by other program products, and retry the
operation.
Check whether the specified R-VOL is a
System Disk.
Check whether the specified R-VOL is a
System Disk.
Install the Continuous Access
Synchronous function to the storage
system.
Install the Continuous Access
Synchronous function to the RCU.
Refresh the window, and confirm
whether the specified volume is an
R-VOL.
Refresh the window, and confirm
whether the status of the specified volume
is SSWS.
Create a path from the RCU to the MCU.
Contact the Support Center, and check
the shared memory.
Refresh the window, and confirm the pair
status of the specified volume.
Check each capacity of the M-VOL and
the R-VOL after the capacity change of
R-VOL ends, and plan a combination of
volumes for pair creating.
Check each capacity of the M-VOL and
the R-VOL after the capacity change of
M-VOL ends, and plan a combination of
volumes for pair creating.
The specified volume is a primary data
volume of the Continuous Access Journal,
which runs on the 2DC configuration in
which the Continuous Access
Synchronous cooperates. Specify another
volume.
Severity
Level
W
W
W
W
W
W
W
W
W
E
W
W
W
W