HP StorageWorks P9000 - Disk Arrays Manual page 248

Table 62 Error codes (part code 7105) (continued)
Part Error
Code Number
7105 8631
7105 8632
7105 8633
7105 8634
7105 8635
7105 8636
7105 8637
7105 8638
7105 8639
7105 8640
7105 8641
7105 8643
7105 8644
7105 8645
7105 8646
7105 8647
7105 8648
248 Message (part code group 7nnn)
Error Message
The specified CU number is invalid.
The timing of issuing the command is
invalid.
The abnormal status is invalid.
The volume specified as a reserved
volume is already defined as a reserved
volume for Auto LUN.
The specified S-VOL is defined as a
reserved volume for Auto LUN.
The specified T-VOL is defined as a
reserved volume for Auto LUN.
The specified S-VOL is used as a source
volume for Auto LUN.
The command has been rejected,
because the specified S-VOL is set for
use in Cache Residency Z.
The command has been rejected,
because the specified T-VOL is set for
use in Cache Residency Z.
The command has been rejected,
because the pair sharing the S-VOL was
in the Reverse Copy or Quick Restore
status.
The pairs contain a pair in the Reverse
Copy status.
The Resynchronize Volume Pair
operation has been rejected, because
the specified pair is not in the state of
Split.
The command has been rejected,
because the pair status is not Split or
Suspend.
The Reverse Copy command has been
rejected, because the S-VOL is shared
as the M-VOL of a Remote Copy pair.
The Reverse Copy request was rejected,
because the S-VOL was shared with a
Remote Copy pair in the non-suspend
status.
The Reverse Copy command has been
rejected, because the T-VOL is shared
with an M-VOL of a Remote Copy pair.
The boot device and the S-VOL do not
match in the AddPair command.
Recommended Action
Please contact HP Technical Support.
Please contact HP Technical Support.
Please contact HP Technical Support.
Specify other volume(s), or release the
Auto LUN setting.
Specify other volume(s), or release the
Auto LUN setting.
Specify other volume(s), or release the
Auto LUN setting.
Specify other volume(s), or release the
Auto LUN setting.
You cannot execute the specified
operation. Release the Cache Residency
Z setting for the operation.
You cannot execute the specified
operation. Release the Cache Residency
Z setting for the operation.
Wait until Reverse Copy or Quick
Restore completes.
You cannot execute the specified
operation. Release the Reverse Copy for
the operation.
The Resynchronize Volume Pair
operation cannot be executed in the
current pair status.
See the section "Rresynchronize pairs"
in the Business Copy for Mainframe
Systems User Guide for the relation
between the state of pairs and the
Business Copy Z operations.
Check the pair status.
You cannot execute the specified
operation. Release the Remote Copy pair
for the operation.
Delete the Remote Copy pair.
Delete the Remote Copy pair.
Check the specified volume number.
Severity
Level
W
E
E
W
W
W
W
W
W
W
W
W
W
W
W
W
W