HP StorageWorks P9000 - Disk Arrays Manual page 151

Table 50 Error codes (part code 6005) (continued)
Part Error Error Message
Code Number
6005 55230 The attribute of the port assigned to
SLPRs except SLPR0 can only be changed
to Target.
6005 56524 This function cannot be used by the
storage partition administrator.
6005 57005 An error occurred during SVP
processing.
6005 58319 A pair cannot be created because the
specified M-VOL is used by Continuous
Access Journal or Continuous Access
Journal Z.
6005 58320 The operation failed because the
specified R-VOL was used by Continuous
Access Journal or Continuous Access
Journal Z.
6005 58321 The pair cannot be created because the
specified M-VOL is a LUSE volume that
is set across multiple CLPRs.
6005 58322 The pair cannot be created because the
specified R-VOL is a LUSE volume that is
set across the multiple CLPRs.
6005 58357 A pair cannot be created, because you
tried to create a volume pair formed with
a volume to which VMA is set by Data
Retention and a volume without VMA.
6005 58358 A pair cannot be created, because the
set processing of VMA that is used for
Data Retention has not been completed
for the specified P-VOL.
6005 58359 A pair cannot be created, because the
set processing of VMA that is used for
Data Retention has not been completed
for the specified S-VOL.
6005 58451 The disk subsystem is in internal process.
Please retry the operation.
Recommended Action
Please contact HP Technical Support.
Please contact HP Technical Support.
If the problem persists despite retrying,
please contact HP Technical Support.
Select another volume, and retry the
operation.
If the Add Pair (Paircreate) operation
failed:
When the RCU runs on the 2DC
configuration in which the Continuous
Access Journal cooperates, wait for
a while until the pair status of the
Continuous Access Journal becomes
"PAIR," then retry the operation.
When the RCU runs on the
configuration other than the 2DC
configuration in which the Continuous
Access Journal cooperates, specify
another volume for R-VOL, then retry
the operation.
If the Pairresync operation failed, resume
the Continuous Access Journal pair
volume first.
Select another volume and retry the
operation.
Select another volume, and retry the
operation.
Check to ensure that you did not
mistakenly attempt to create a volume
with or without VMA.
Wait a while, then retry the operation.
Wait a while, then retry the operation.
If the problem persists despite retrying,
please contact HP Technical Support.
Severity
Level
E
E
E
W
W
W
W
W
W
W
W
Part code 6005 151