HP StorageWorks P9000 - Disk Arrays Manual page 63

Table 26 Error codes (part code 01022) (continued)
Part Error Error Message
Code Number
01022 105049 You are trying to register the same host
that has already existed as a candidate.
01022 105050 The specified HBA WWN cannot be
registered, because it is already used in
this port.
01022 105051 The specified Host Name cannot be
registered, because it is already used in
this port.
01022 105052 There is no port information on the copy
target.
01022 105070 The same host is specified at the same
time.
01022 105071 The attribute of the specified port is
neither Target nor RCU Target.
01022 105072 The same host cannot be added in the
same port.
01022 105073 [Finish] is clicked without completing the
setting.
01022 105074 All the check boxes are being cleared.
01022 105075 The HBA WWN about to be changed
has already existed in the same port.
01022 105076 The host name about to be changed has
already existed in the same port.
01022 105077 The specified port type is not Fibre Port.
01022 105079 Changing to the external or the initiator
port cannot be done, because a host
group other than Host Group 0 is set.
01022 105080 Changing to External or Initiator port
cannot be done, because a host or a
path is set.
01022 105081 The setting cannot be changed because
of the unsupported port speed.
01022 105082 The specified port does not exist in the
configuration.
01022 105083 There is a radio button that is not
selected.
01022 105084 The setting cannot be changed, because
an invalid value has been input.
01022 105085 The setting cannot be changed, because
the value of UUID is outside the range.
01022 105086 The input value of the starting LUN ID is
outside the range.
Recommended Action
Check the setting(s).
Check the setting(s).
Check the setting(s).
Check the setting(s).
Check the setting(s).
Check the setting(s).
Check the setting(s).
Check the setting(s).
Check the check boxes for the items that
you want to change, then retry the
operation.
Check the setting(s).
Check the setting(s).
Check the setting(s).
Check the setting(s).
Check the setting(s).
Check the channel PCB.
Retry the operation. If the same problem
occurs again, close the windows, refresh
it, then retry again. If the same problem
persists despite retrying, please contact
HP Technical Support.
Check the setting(s).
Check the setting(s).
Check the setting(s).
Check the setting(s).
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
E
W
W
W
W
Part code 01022 63