HP StorageWorks P9000 - Disk Arrays Manual page 239

Table 61 Error codes (part code 7010) (continued)
Part Error Error Message
Code Number
7010 51 18 The MU number was not selected.
7010 51 19 No P-VOL is selected.
7010 5120 No S-VOL is selected.
7010 5121 The data has been changed. If you select
another tab (page), the settings will be
discarded. Are you sure you want to
continue?
7010 5122 No data has been changed.
7010 5123 The password is invalid.
7010 5124 You cannot select more than one
operation at a time.
7010 5125 No target volume is selected.
7010 5126 You cannot create another L2 pair,
because the number of L2 pairs exceeds
the maximum.
7010 5127 The specified MU number is invalid.
Select another MU number.
7010 6504 The number of L1 pairs exceeds the
maximum.
7010 6505 The number of L2 pairs exceeds the
maximum.
7010 7310 Unregistered error code.
7010 731 1 The settings could not be applied.
7010 7312 The password could not be acquired.
7010 7313 Error details not available.
7010 7440 An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
7010 8534 An internal logic contradiction occurred.
7010 8568 The Emulation Type is invalid.
7010 8658 Some settings could not be applied
normally. Refer to the error code.
7010 8659 The PCB required for this operation is
not mounted. Check the subsystem
configuration.
7010 9002 The request operation has completed.
Recommended Action
Select MU number.
Select P-VOL, and operate.
Select S-VOL, and operate.
Apply the data in the Preview list. To
stop the transaction, click [OK] and
continue the operation.
Go on to the next operation.
Check the password.
Multiple volumes cannot be processed
in the operation. Process one volume at
a time.
Select the target volume.
You cannot create L2 pair for the
specified P-VOL. Delete the created L2
pair, and retry the operation.
Select the other MU number.
You cannot create L1 pair for the
specified P-VOL. Delete the created L1
pair, and retry the operation.
You cannot create L2 pair for the
specified P-VOL. Delete the created L2
pair, and retry the operation.
Please contact HP Technical Support.
Wait a while, and retry the operation.
If the same error occurs despite retrying,
please contact HP Technical Support.
Please contact HP Technical Support.
Please contact HP Technical Support.
If this problem persists please contact HP
Technical Support.
Please contact HP Technical Support.
Specify the volume of the supported
emulation type.
Check the error code in the Preview list.
Mount the required PCB, then retry the
operation.
The operation was ended normally.
Execute the next operation.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
E
W
E
E
E
i
i
W
W
i
Part code 7010 239