HP StorageWorks P9000 - Disk Arrays Manual page 166

Table 53 Error codes (part code 6505) (continued)
Part Error
Code Number
6505 7310
6505 8000
6505 8001
6505 8002
6505 8100
6505 8102
6505 8700
6505 8701
6505 8702
6505 8703
6505 8704
6505 8705
6505 8706
6505 8708
6505 8709
6505 8710
6505 871 1
166 Message (part code group 6nnn)
Error Message
This error code is not registered.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
A communication time-out error occurred
in the subsystem. Please wait for a while,
and then retry the operation.
A communication time-out error occurred
in the subsystem. Please wait for a while,
and then retry the operation.
An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
This function is not supported.
Please retry operation.
The logical path between the local and
the remote subsystems is invalid.
The status of the primary data volume is
not valid.
The specified number of paths is less
than the minimum number of paths in the
DKC Option window.
The specified number of paths is less
than the minimum number of paths in the
DKC Option window, due to a
communication error between the local
and the remote storage systems.
The path could not be deleted due to a
communication error between the local
and the remote subsystems.
Parameter specified by Remote Copy
operation is invalid.
The pair status of the secondary data
volume is incorrect.
Remote Copy operation was rejected.
The pair status of the specified data
volume is incorrect.
The specified parameter is incorrect.
Recommended Action
If the same error occurs despite retrying,
please contact HP Technical Support.
Retry the operation. If this problem
persists, please contact HP Technical
Support.
Wait a while, then retry the operation.
Wait a while, then retry the operation.
Retry the operation. If this problem
persists, please contact HP Technical
Support.
Check whether the DKCMAIN microcode
version and the SVP microcode version
are mismatched.
Retry the operation.
Check the path status and edit the path
again.
Refresh and check the window. If
possible, retry the operation on the
primary data volume.
Check the number of paths.
Check the path status in the DKC Status
window, then restore the paths.
Check the CHA status on the window. If
the CHA is blocked, replace the CHA,
then retry the operation.
Enter the correct data.
Refresh the window, and check the pair
status. If possible, retry the operation on
the secondary data volume.
Replace the channel adapter, then retry
the operation.
Refresh the window, and check the pair
status of the pair. If the pair status can
be manipulated, retry the operation.
Check the port number, ID, and LUN of
the storage system.
Severity
Level
E
E
W
W
E
E
W
W
W
W
W
E
W
W
E
W
W