Cisco SR2016T-NA Reference Manual page 788

main-cpu
main-cpu
To enter main-CPU redundancy configuration mode, so that you can configure the synchronization of
the active and standby Performance Routing Engine (PRE1) modules, use the main-cpu command in
redundancy configuration mode.
Syntax Description
This command has no keywords or arguments.
Defaults No default behavior or values
Command Modes Redundancy configuration
Command History Release
12.2(4)XF
12.2(11)BC3
Usage Guidelines
When you enter main-CPU redundancy configuration mode, the prompt changes to the following:
Router(config-r-mc)#
After you enter main-CPU redundancy configuration mode, you can use the
specify which files are synchronized between the active and standby PRE1 modules. In Cisco IOS
Release 12.2(11)BC3 and later releases, you can also use the
the amount of time that the standby PRE1 module should wait when it first detects that the active PRE1
module is not active and when it initiates a switchover and becomes the active PRE1 module.
To leave main-CPU redundancy configuration mode and to return to redundancy configuration mode, use
the exit command.
Examples
The following example shows how to enter main-CPU redundancy mode and the commands that are
available there:
Router# config t
Router(config)# redundancy
Router(config-r)# main-cpu
Router(config-r-mc)# ?
Main Cpu redundancy configuration commands:
auto-sync
exit
no
switchover
Router(config-r-mc)#
Cisco Broadband Cable Command Reference Guide
4-28
main-cpu
Modification
This command was introduced for the Cisco uBR10012 router.
Support for the
Sync elements
Exit from main-cpu configuration mode
Negate a command or set its defaults
Configuration of switchover
Chapter 4
switchover timeout command was added.
switchover timeout
Commands for the Cisco uBR10012 Router
auto-sync command to
command to specify
OL-1581-08