Table of Contents
Advertisement
cable telco-return spd username
cable telco-return spd username
To set the username that the telco-return CM uses for authentication when establishing a PPP connection
with the access server, use the cable telco-return spd username command in cable interface
configuration mode. To restore the default value, use the no form of this command.
Syntax Description
spd-number
login-string
Defaults
The default value is guest.
Command Modes
Interface configuration (cable interface only)
Command History
Release
12.0(4)XI
Usage Guidelines
This command sets the Login Username parameter for the specified SPD in the Telephony Channel
Descriptor (TCD) messages.
This command is available only in images that support telco-return. These images have a "t" as part of
Note
the image name.
Examples
The following example shows the username being set to "sandy" for SPD 3:
router(config-if)# cable telco-return spd 3 username sandy
Related Commands
Command
cable telco-return enable
cable telco-return interval
cable telco-return
registration-ip
Cisco Broadband Cable Command Reference Guide
2-278
cable telco-return spd spd-number username login-string
no cable telco-return spd spd-number username login-string
Service provider descriptor (SPD) number for which this parameter is
set. Valid range is 1 through 5.
Username that the CM uses for authentication during the initialization
procedure.
Modification
This command was introduced.
Description
Enables telco-return functionality.
Defines the interval for sending TCD and Termination System
Information (TSI) messages.
Selects a different IP address for the telco-return CM to send its
registration requests.
Chapter 2
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
