Table of Contents
Advertisement
show voice port
Voice card specific Info Follows:
Signal Type is loopStart
Ring Frequency is 25 Hz
Hook Status is On Hook
Ring Active Status is inactive
Ring Ground Status is inactive
Tip Ground Status is inactive
Digit Duration Timing is set to 100 ms
InterDigit Duration Timing is set to 100 ms
Router#
Table 6-34
Table 6-34 show voice port Field Descriptions
Field
Type of VoicePort
Operations State
Administrative State
Interface Down Failure
Description
Noise Regeneration
Non Linear Processing
Music On Hold Threshold
In Gain
Out Attenuation
Echo Cancellation
Echo Cancel Coverage
Connection Mode
Connection Number
Initial Time Out
Interdigit Time Out
Call-Disconnect Time Out
Ringing Time Out
Region Tone
Currently Processing
Maintenance Mode
Number of signaling protocol
errors
Impedance
Cisco Broadband Cable Command Reference Guide
6-178
describes the fields shown in this display.
Description
Type of voice port: always FXS for the cable access router.
Operation state of the port.
Administrative state of the voice port.
Last interface down failure that was reported, if any.
Description of the voice port, if any.
Whether or not background noise should be played to fill silent
gaps if VAD is activated.
Whether or not nonlinear processing is enabled for this port.
Configured music-on-hold threshold value for this interface.
Amount of gain inserted at the receiver side of the interface.
Amount of attenuation inserted at the transmit side of the interface.
Whether or not echo cancellation is enabled for this port.
Echo cancel coverage for this port.
Connection mode of the interface.
Full E.164 telephone number used to establish a connection with
the trunk or PLAR mode.
Amount of time the system waits for an initial input digit from the
caller.
Amount of time the system waits for a subsequent input digit from
the caller.
Number of seconds for an idle call to be disconnected.
Ringing time out duration.
Configured regional tone for this interface.
Type of call currently being processed: none, voice, or fax.
Maintenance mode of the voice port.
Number of signalling protocol errors.
Configured terminating impedance for the E&M interface.
Chapter 6
Cable CPE Commands
OL-1581-07
Advertisement
Table of Contents
