Cisco SR2016T-NA Reference Manual page 436

Reference guide

Hide thumbs Also See for SR2016T-NA:

Table of Contents

To manually synchronize the Inter-database between the Working and Protect interfaces for a particular

member in an Hot Standby Connection-to-Connection Protocol (HCCP) group, use the hccp resync

command in privileged EXEC mode.

Syntax Description

No default behavior or values.

Command Modes

Privileged EXEC

Command History

Usage Guidelines

The Cisco CMTS automatically synchronizes the Working and Protect interfaces to ensure that when a

switchover occurs, the Protect interface will run with a configuration that is identical to that of the

Working interface. However, if you are troubleshooting HCCP problems, you can manually

resynchronize the databases using the hccp resync command before performing any switchover tests.

When a SYNC event command is occurring, CLI commands might be very slow to respond. In particular,

if you enter a show command at the same time a SYNC event is occurring, the command might respond

produce a blank display, or it might display an error message similar to the following:

%No response from slot 6/1. Command aborted

If this occurs, wait a minute or so and retry the command.

The following example shows how to manually resynchronize the Inter-database between the Working

and Protect interfaces for member 4 in HCCP group 13:

Router# hccp 13 resync 4

Cisco Broadband Cable Command Reference Guide

hccp group resync member

The group number for the specified interface. The valid range is 1 to 255.

The member ID to be resynchronized. The valid range is 1 to 255.

Modification

This command was introduced for the Cisco uBR10012 router and

Cisco uBR-LCP-MC28C card with the Cisco RF Switch.

Support was added for the Cisco uBR10012 router using the Cisco uBR-

LCP-MC16C, Cisco uBR-LCP-MC16E, and Cisco uBR-LCP-MC16S

cards with the Cisco RF Switch.

Support was added for the Cisco uBR7246VXR router and Cisco uBR-

MC16C, Cisco uBR-MC16S, and Cisco uBR-MC28C cards with the

Cisco RF Switch.

Cisco CMTS Configuration Commands

Broadband cable