Table of Contents
Advertisement
hccp lockout
hccp lockout
To prevent a Working CMTS from automatically switching to a Protect CMTS in the same group, use
the hccp lockout command in privileged EXEC mode.
This command is applicable only to Working CMTS in a given group. Issuing this command on a Protect
Note
CMTS has no effect.
Syntax Description
group
member
Defaults
By default, the hccp lockout command is inactive.
Command Modes
Privileged EXEC
Command History
Release
12.1(3a)EC
12.1(7)EC1
12.2(4)XF1,
12.2(4)BC1
12.2(8)BC2
12.2(11)BC1
Usage Guidelines
Typically the hccp lockout command is used to disable HCCP switchovers before removing the HCCP
configuration on the Working interface. Otherwise, when you remove the HCCP configuration from the
Working interface, the Protect interface assumes the Working interface has failed and switches over.
You might also want to prevent a Working CMTS from automatically switching back to a Protect CMTS
for testing or additional configuration purposes. For example, you might want to fully test protecting
cable interfaces on your Cisco CMTS before returning it to protect status.
Examples
The following example shows how to activate the lockout feature of a Working CMTS in group 1:
router# hccp 1 lockout
Cisco Broadband Cable Command Reference Guide
2-420
hccp group lockout member
The group number for the specified interface. Valid values are any number
from 1 to 255, inclusive.
The member number within the specified group.
Modification
This command was introduced for the Cisco uBR7200 series routers.
Support was added for the Cisco uBR-MC16S cable interface line card.
Support was added for the N+1 (1:n) RF Switch with the Cisco uBR10012
router and Cisco uBR-LCP-MC28C card.
Support was added for the N+1 (1:n) RF Switch with the Cisco uBR10012
router and Cisco uBR-LCP-MC16C, Cisco uBR-LCP-MC16E, and
Cisco uBR-LCP-MC16S cards.
Support was added for the N+1 (1:n) RF Switch with the
Cisco uBR7246VXR router and Cisco uBR-MC16C, Cisco uBR-MC16S,
and Cisco uBR-MC28C cards.
Chapter 2
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
