Cisco SR2016T-NA Reference Manual page 529

Chapter 3 Cisco CMTS Show Commands
show cable host access-group
To display the hosts and other customer premises equipment (CPE) devices behind the CMs in the
network, along with their access groups, use the show cable host access-group command in privileged
EXEC mode.
The show cable host command is not supported on the Cisco uBR10012 universal broadband router.
Note
Syntax Description mac-addr
ip-addr
Command Modes
Privileged EXEC
Command History Release
11.NA
12.1(3a)EC1
12.2(4)BC1
Usage Guidelines
This command displays information only for hosts and other CPE devices. To display information for
CMs and their associated CPE devices, use the
information only for CMs, use the
If an SNMP manager is requesting information about CM or CPE devices at the same time that this
command is given, the command displays the following error message:
No information is available, please try later.
Wait until the SNMP retrieval is done and retry the CLI command.
Examples The following example shows how to display all the hosts behind the CMs in the network:
router# show cable host access-group
MAC address
0080.c6f9.b42e
0020.7806.defe
0050.baa0.5ccd
0050.046f.f4cf
0050.bacf.5d89
0050.1800.a8cb
0040.d00f.44f0
0050.e456.9641
OL-1581-08
show cable host [ip-address | mac-address] access-group
(Optional) Specifies the 48-bit hardware address for a particular CM or host.
(Optional) Specifies the IP address for a particular CM or host.
Modification
This command was introduced.
Support was added to the Release 12.1 EC train.
Support was added to the Release 12.2 BC train for the Cisco uBR7100
series and Cisco uBR7200 series routers. (This command also appears in
the CLI for the Cisco uBR10012 router but is not functional.)
IP address
24.168.220.52
192.168.28.134
24.168.223.251
192.168.33.25
192.168.37.113
192.168.33.90
192.168.34.128
192.168.39.66
show cable device access-group
show cable modem access-group
Type Access-group
host
host
host
host
host
host
host
host
Cisco Broadband Cable Command Reference Guide
show cable host access-group
command. To display
command.
3-33