Cisco SR2016T-NA Reference Manual page 705

Chapter 3 Cisco CMTS Show Commands
show interface cable downstream
To display information about the downstreams on a cable interface, use the show interface cable
downstream command in privileged EXEC mode.
Syntax Description
slot/port
slot/subslot/port
Defaults No default behavior or values
Command Modes
Privileged EXEC
Command History Release
11.3 XA
12.0(3)T
12.1(4)CX
12.2(4)BC1
Examples The following example is sample output from the show interface cable downstream command for
Cisco IOS releases that support only DOCSIS 1.0 or 1.0+ operation:
CMTS01# show interface cable 6/0 downstream
Cable6/0: Downstream is up
The following is sample output from the show interface cable downstream command for Cisco IOS
releases that support only DOCSIS 1.1 operation:
Router# show interface cable 4/0 downstream
Cable4/0:Downstream is up
OL-1581-08
show interface cable {slot/port | slot/subslot/port} downstream
Modification
This command was introduced.
Command ported to the mainline release.
Output was expanded for show interface cable downstream command for
DOCSIS 1.1 operation.
Support was added to the Release 12.2 BC train.
111947771 packets output, 1579682655 bytes, 0 discarded
0 output errors
Identifies the cable interface and downstream port on the
Cisco uBR7100 series and Cisco uBR7200 series routers.
On the Cisco uBR7100 series router, the only valid value is 1/0. On
the Cisco uBR7200 series router, slot can range from 3 to 6, and
port can be 0 or 1, depending on the cable interface.
Identifies the cable interface on the Cisco uBR10012 router. The
following are the valid values:
• slot = 5 to 8
subslot = 0 or 1
•
port = 0 to 4 (depending on the cable interface)
•
Cisco Broadband Cable Command Reference Guide
show interface cable downstream
3-209