Table of Contents
Advertisement
show cable bundle
Table 3-4
Table 3-4
Field
MAC address
Interface
Flag
Location
link
sublink
In Cisco IOS Release 12.1(12)EC, Release 12.2(8)BC1, and later releases, you can add a timestamp to
Tip
show commands using the exec prompt timestamp command in line configuration mode.
Related Commands
Command
cable bundle
Cisco Broadband Cable Command Reference Guide
3-12
describes the fields shown in the show cable bundle command display.
show cable bundle Command Field Descriptions
Description
Identifies the MAC (hardware) address for each interface in the
bundle.
Identifies the cable interface slot and port number.
The current value of the flag byte for this bundle entry. The
following bits can be set:
•
•
Note
The location in the router's memory for the flags byte for this
bundle entry. This value is useful only to TAC engineers during
debugging.
The value of the link pointer for this bundle entry. This value is
useful only to TAC engineers during debugging.
The value of the sublink pointer for this bundle entry. This value is
useful only to TAC engineers during debugging.
Description
Creates an interface bundle.
Bit 0 (0x01) = Bundle is active.
Bit 1 (0x02) = Bundle is a static multicast group.
If more than one bit is set, add the values together. For
example, 3 indicates an active, static multicast group.
Chapter 3
Cisco CMTS Show Commands
OL-1581-08
Advertisement
Table of Contents
