Table of Contents
Advertisement
show interfaces usb
show interfaces usb
To display configuration information about the USB interface, use the show interfaces usb command in
privileged EXEC mode.
Cisco uBR925 cable access router, Cisco CVA122 Cable Voice Adapter
Syntax Description:
number
Command Modes
Privileged EXEC
Command History
Release
12.1(5)XU1
12.2(2)XA
Examples
The following shows typical output from the show interfaces usb command:
Router# show interface usb0
USB0 is up, line protocol is down
Hardware is M850_USB, address is 0001.64f9.22fe (bia 0001.64f9.22fe)
Internet address is 192.168.100.1/24
MTU 1500 bytes, BW 12000 Kbit, DLY 1000 usec,
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
ARP type:ARPA, ARP Timeout 00:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy:fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
Router#
In Cisco IOS Release 12.2(8)T and later releases, you can add a timestamp to show commands using the
Tip
exec prompt timestamp command in line configuration mode.
Cisco Broadband Cable Command Reference Guide
6-172
show interfaces usb number
Identifies the USB interface (always 0).
Modification
This command was introduced for the Cisco CVA122 Cable Voice Adapter.
Support was added for the Cisco uBR925 cable access router.
reliability 255/255, txload 1/255, rxload 1/255
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
2 packets output, 120 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Chapter 6
Cable CPE Commands
OL-1581-07
Advertisement
Table of Contents
