Table of Contents
Advertisement
show controllers cable-modem qos
Table 6-16 show controllers cable-modem qos Field Descriptions (DOCSIS 1.1) (continued)
Field
TX Pkts
TX Bytes
RX Pkts
RX Bytes
Capabilities
cbr
cc
fr
nbr
Queue/SF Type
Packet Classifiers
Class id
SFID
Pri
Cisco Broadband Cable Command Reference Guide
6-126
Description
Number of packets the router has transmitted on this service flow.
Number of bytes the router has transmitted on this service flow.
Number of packets the router has received on this service flow.
Number of bytes the router has received on this service flow.
These four fields describe whether the following features are enabled.
Indicates whether committed bit rate traffic (CBR) is supported (T) or not
(F). This could indicate either UGS or UGS-AD service flows.
Indicates whether concatenation is supported (T) or not (F).
Indicates whether DOCSIS fragmentation is supported (T) or not (F).
Indicates the Not Broadcast status, depending on whether the classifier
supports broadcasts (F) or not (T).
Identifies the type of service flow being used for each queue.
Describes the classifiers defined on the router.
ID used to uniquely identify the classifier in each service flow.
ID that uniquely identifies the service flow.
Traffic Priority parameter that was assigned to this classifier. If no value
was set, the priority defaults to 0 (lowest priority).
Chapter 6
Cable CPE Commands
OL-1581-07
Advertisement
Table of Contents
