Table of Contents
Advertisement
associate
associate
To logically associate two line cards within the router for Automatic Protection Switching (APS)
redundancy, use the associate command in redundancy configuration mode. To disable slot associations,
use the no form of this command.
Syntax Description
slot
slot1
slot2
Defaults
Slots are not associated.
Command Modes
Redundancy configuration
Command History
Release
12.2(4)XF1
12.2(13)BC1
Usage Guidelines
The associate command associates the cards in two slots for APS redundancy protection. The two cards
must be in adjacent slots, with the working card in slot 1 or 3, and the backup card in slot 2 or 4,
respectively. The two cards must be identical cards and must support APS redundancy (such as the
OC-12 POS line card).
Note
You cannot use the associate command with Performance Routing Engine (PRE1) modules or TCC+
cards, because these cards are automatically configured for redundant operation when two cards are
installed in the chassis.
Examples
The following example shows how to associate the OC-12 POS card in slot 1/0 with the OC-12 POS card
in slot 2/0 on the Cisco uBR10012 router:
Router# config t
Router(config)# redundancy
Cisco Broadband Cable Command Reference Guide
4-6
associate slot slot1 [slot2]
no associate slot slot1 [slot2]
Specifies that redundancy is being set between two full-height slots.
Specifies the slot that contains the working (primary) card. The valid range
is 1 to 8 (odd numbers only), but on the Cisco uBR10012 router, the only
usable numbers are 1 and 3, and the card must support APS redundancy.
(Optional) Specifies the slot that contains the redundant (backup) card. The
valid range is 1 to 8 (even numbers only), but on the Cisco uBR10012
router, the only usable numbers are 2 and 4. If not specified, the next higher
adjacent slot is automatically configured as the redundant slot.
Modification
This command was introduced for the Cisco uBR10012 router.
Support was added for the Cisco OC-48 DPT/POS adapter card on the
Cisco uBR10012 router.
Chapter 4
Commands for the Cisco uBR10012 Router
OL-1581-08
Advertisement
Table of Contents
