Cisco SR2016T-NA Reference Manual page 690

Reference guide
Hide thumbs Also See for SR2016T-NA:
Table of Contents

Advertisement

show hccp
Release
12.2(11)BC1
12.2(15)BC2
Examples
The following examples are from the show hccp and show hccp brief commands for the entire chassis:
Router# show hccp
Cable4/0 - Group 1 Protect, enabled, blocking
authentication md5, key-chain "cisco1"
hello time 2000 msec, hold time 6000 msec
Member 1 standby
ip addr: working 10.20.111.11, protect 10.20.111.10
downstream wavecom (1.1.11.3/1, 1.1.11.3/2), upstream none
Router# show hccp brief
Interface Config
Ca5/0/0
Ca7/0/0
In Cisco IOS Release 12.2(8)BC2 and later 12.2 BC releases, the brief option also shows the amount of
time left before the next resynchronization and the time left before a restore:
Router# show hccp brief
Interface Config
Ca5/0/0
Ca7/0/0
Router#
The following example shows typical output for the show hccp channel-switch command, displaying
the groups and module numbers for each configured member:
Router# show hccp channel-switch
Grp 1 Mbr 1 Working channel-switch:
Grp 2 Mbr 1 Working channel-switch:
Grp 1 Mbr 7 Protect channel-switch:
Cisco Broadband Cable Command Reference Guide
3-194
Modification
Support was added for the Cisco uBR-RFSW N+1 (1:n) RF Switch with the
Cisco uBR7246VXR router and Cisco uBR-MC16C, Cisco uBR-MC16S,
and Cisco uBR-MC28C cards.
The output of the show hccp detail command was changed to show separate
lists of the critical and non-critical CLI commands that are being
synchronized for each Working and Protect interface and subinterface.
Grp Mbr Status
Protect
1
3
Working
1
3
Grp Mbr Status
Protect
1
3
Working
1
3
"uc" - enabled, frequency 555000000 Hz
"rfswitch" - module 1, normal
module 3, normal
module 5, normal
module 7, normal
module 11, normal
"uc" - enabled, frequency 555000000 Hz
"rfswitch" - module 2, normal
module 4, normal
module 6, normal
module 9, normal
module 13, normal
"uc" - disabled, frequency 555000000 Hz
"rfswitch" - module 1, normal
module 3, normal
standby
active
WaitToResync
standby
active
00:00:50.892
Chapter 3
Cisco CMTS Show Commands
WaitToRestore
00:01:50.892
00:01:50.892
OL-1581-08

Advertisement

Table of Contents
loading

This manual is also suitable for:

Broadband cable

Table of Contents