Cisco SR2016T-NA Reference Manual page 570

Reference guide

Hide thumbs Also See for SR2016T-NA:

Table of Contents

show cable modem connectivity

Usage Guidelines

This command displays connectivity information for all CMs, for all CMs attached to a specific CMTS

cable interface, or for a particular CM, as identified by its IP address or MAC address.

The show cable modem connectivity command replaces the connectivity option for the

on a per-SID basis.

Also see the information about this command's behavior in a Hot Standby Connection-to-Connection

Protocol (HCCP) configuration, see the

Protocol (HCCP) Configuration" section on page

The following example shows sample output for the show cable modem connectivity command for all

Router# show cable modem connectivity

The following example shows sample output for the show cable modem connectivity command for all

online CMs for a particular cable interface:

Router# show cable modem c8/1/0 connectivity

The following example shows sample output for the show cable modem connectivity command for a

particular CM:

Router# show cable modem 0010.7bb3.fcd1 connectivity

Cisco Broadband Cable Command Reference Guide

command, because the connectivity statistics are better managed on a per-modem basis than

Apr 28 2003 1

Apr 28 2003 1

Apr 28 2003 1

Apr 28 2003 1

Apr 28 2003 1

Apr 28 2003 1

May 30 2000 4

describes the information shown in the show cable modem connectivity displays:

"Operation with Hot Standby Connection-to-Connection

1d1h12m 1d1h12m 05:38

1d1h11m 1d1h11m 05:46

1d1h11m 1d1h11m 05:18

1d2h23m 00:01

Cisco CMTS Show Commands

show interface

Offline time

Offline time

Offline time

Broadband cable