Clear Cable Modem Reset - Cisco SR2016T-NA Reference Manual

clear cable modem reset

clear cable modem reset
To remove one or more CMs from the Station Maintenance List and reset them, use the clear cable
modem reset command in privileged EXEC mode.
Syntax Description mac-addr
ip-addr
cable slot/port
cable slot/subslot/port
all
oui string
reject
Defaults
No default behavior or values
Command Modes Privileged EXEC
Command History Release
12.1(2) EC
12.2(4)BC1
12.2(11)BC2
Cisco Broadband Cable Command Reference Guide
2-388
clear cable modem {mac-addr | ip-addr | [cable slot/port] {all | oui string | reject} } reset
clear cable modem {mac-addr | ip-addr | [cable slot/subslot/port] {all | oui string | reject} } reset
Modification
This command was introduced.
Support was added to the Release 12.2 BC train.
Support was added for the oui and reject options.
Specifies the 48-bit hardware address (MAC address) of an individual
CM, or of any CPE devices or hosts behind that CM.
Specifies the IP address of an individual CM, or of any CPE devices or
hosts behind that CM.
(Optional) Identifies the a interface and downstream port on the
Cisco uBR7100 series and Cisco uBR7200 series routers.
On the Cisco uBR7100 series router, the only valid value is 1/0. On the
Cisco uBR7200 series router, slot can range from 3 to 6, and port can
be 0 or 1, depending on the cable interface.
(Optional) Identifies a cable interface on the Cisco uBR10012 router.
The following are the valid values:
slot = 5 to 8
•
subslot = 0 or 1
•
• port = 0 to 4 (depending on the cable interface)
Removes all the CMs from the Station Maintenance List. (This option
is valid only on the Release 12.1 EC train.)
Removes and resets all CMs that match the specified Organization
Unique Identifier (OUI). The string parameter can be either the three
byte hexadecimal string (such as 00.00.0C) or a vendor name that has
been defined using the cable modem vendor
Removes and resets all CMs that are currently in one of the reject states
(see the description of these states in the
command).
Chapter 2 Cisco CMTS Configuration Commands
command.
show cable modem
OL-1581-08