Table of Contents
Advertisement
monitoring-duration
Figure 1
each sample-rate interval period.
Figure 1
When you change the configuration of a currently active enforce-rule, that rule begins using the new
configuration immediately to manage the cable modems tracked by this enforce-rule.
Examples
The following example shows an enforce-rule being configured for a monitoring window that is 20
minutes in length, with a sampling rate of every 10 minutes.
Router# configure terminal
Router(config)# cable qos enforce-rule residential
Router(enforce-rule)# monitoring-duration 20 sample-interval 10
Router(enforce-rule)# exit
Router(config)#
The following example shows the error message that is displayed when the sample-rate period is
configured to be greater than the monitoring-duration period. In this situation, the command is ignored
and the parameters remain unchanged:
Router# configure terminal
Router(config)# cable qos enforce-rule residential
Router(enforce-rule)# monitoring-duration 20 sample-interval 30
Monitoring duration cannot be less than the Sampling interval -- so the values
would remain unchanged
Router(enforce-rule)#
Related Commands
Command
activate-rule at-byte-
count
cable qos enforce-rule
Cisco Broadband Cable Command Reference Guide
2-446
illustrates how this process works, with a new sliding window beginning at the beginning of
Monitoring-Duration Windows
Sample-Rate Intervals
Monitoring-Duration
Window 1
Monitoring-Duration
Window 2
Monitoring-Duration
Window 3
Description
Specifies the number of bytes that a subscriber can transmit during the
monitoring period.
Creates an enforce-rule to be used to enforce a particular quality of service
(QoS) profile and enters enforce-rule configuration mode.
Chapter 2
Monitoring-Duration
Window 4
Cisco CMTS Configuration Commands
. . .
OL-1581-08
Advertisement
Table of Contents
